motor extraction/insertion

  • Old Man Rock
  • Old Man Rock's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6071
  • Thanks: 225

Re: motor extraction/insertion

14 Jan 2009 04:03 - 14 Jan 2009 04:07
#257813
The easiest method I found (one person job) is with the bike stripped to the frame minus the motor... Front end off and at least rear tire off.

Frame on ground/boards, bolts loose.
Tape of frame where motor may chip/scratch during removal.
Towel laid out on floor, right side of bike.
Remove bolts and motor mounts.
Remove top end valve cover, cams & head.
Standing over bike straddled.
Slightly lift & remove engine out of right side.

Now lift and carry onto work table/bench.

Installation is the reversed.

One Man Job...

OMR
1976 KZ900-A4
MTC 1075cc.
Camshafts: Kawi GPZ-1100 .375 lift
Head: P&P via Larry Cavanaugh
ZX636 suspension
MIKUNI, RS-34'S...
Kerker 4-1, 1.5" comp baffle.
Dyna-S E.I.
Earls 10 row Oil Cooler
Acewell 2802 Series Speedo/Tach
Innovate LC1 Wideband 02 AFR meter

Phoenix, Az
Last edit: 14 Jan 2009 04:07 by Old Man Rock.

Please Log in or Create an account to join the conversation.

  • Old Man Rock
  • Old Man Rock's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6071
  • Thanks: 225

Re: motor extraction/insertion

14 Jan 2009 04:08
#257815
or....
1976 KZ900-A4
MTC 1075cc.
Camshafts: Kawi GPZ-1100 .375 lift
Head: P&P via Larry Cavanaugh
ZX636 suspension
MIKUNI, RS-34'S...
Kerker 4-1, 1.5" comp baffle.
Dyna-S E.I.
Earls 10 row Oil Cooler
Acewell 2802 Series Speedo/Tach
Innovate LC1 Wideband 02 AFR meter

Phoenix, Az

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum