Split cases, old KZ pro needed...

  • mark1122
  • mark1122's Avatar
  • Offline
  • User
  • User
    Registered
  • Keep twisting it
  • Posts: 5297
  • Thanks: 109

Re: Split cases, old KZ pro needed...

14 Apr 2012 18:10
#515796
i dont recall if there is a side play measurement. just measure everything that is listed, and if its all in spec u r good to go.
76 KZ, frame gusset work,1200CC.Ported by Larry Cavanaugh, 1.5mm.over intakes, Carron Pipe, ZRX12 rear end, and seat,96zx9 front end.
01 CBR600F4i Track bike.
Cobourg, Ont. Can.

~ ~ ~_@
~ ~ _- \,
~ (k) / (z)

Please Log in or Create an account to join the conversation.

  • Garn
  • Garn's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 265
  • Thanks: 13

Re: Split cases, old KZ pro needed...

14 Apr 2012 19:17 - 14 Apr 2012 19:18
#515812
I did read somewhere in a Factory manual that they adjust the end-float in shafts by a different thickness shim washers. Check existing gears for any rounding of drive pins, or their corresponding slots/holes), as this is where end-float will affect gear engagement.
1 x 73 Z1 (Jaffa), 74 Z1A, 76 Z900-A4
1 x 73 Yamaha TX500 & 98 fzx250 Zeal
Sydney Australia
Last edit: 14 Apr 2012 19:18 by Garn.

Please Log in or Create an account to join the conversation.

  • notaduc
  • notaduc's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 297
  • Thanks: 3

Re: Split cases, old KZ pro needed...

15 Apr 2012 15:58
#515957
I am still really hoping to hear from someone who has seen/dealt with cases that looked this way.
1980 (mostly) KZ1000

Please Log in or Create an account to join the conversation.

  • notaduc
  • notaduc's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 297
  • Thanks: 3

Re: Split cases, old KZ pro needed...

18 Apr 2012 01:40
#516436
Went to see John Pearson today. He assures me that my cases look typical/fine...

He is very informative and friendly. Im happy to give him my business...
1980 (mostly) KZ1000

Please Log in or Create an account to join the conversation.

  • andy9802gt
  • andy9802gt's Avatar
  • Offline
  • User
  • User
    Registered
  • If it tastes that good, eat it yourself.
  • Posts: 695
  • Thanks: 19

Re: Split cases, old KZ pro needed...

18 Apr 2012 05:36
#516446
notaduc wrote: Went to see John Pearson today. He assures me that my cases look typical/fine...

He is very informative and friendly. Im happy to give him my business...

Told ya they were okay.
'78 KZ1075 LTD
stage 1 head by Larry Cavanaugh
race built crank by John Pearson
Mikuni rs34's
k410 cams
back cut tranny
8" over D&G swinger
proving once again that age and treachery is better than youth and enthusiasm

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum