Engine rebuild?

  • KZ1000inaus
  • KZ1000inaus's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Luminous Red KZ1000 A2
  • Posts: 135
  • Thanks: 4

Re: Engine rebuild?

11 Jul 2012 23:14
#535362
Patton wrote:
KZ1000inaus wrote:
Street Fighter LTD wrote: No piston ring compressor needed. Shop manual will see you thru install, NOTE; Gap rings then Make sure rings are indexed correctly so end gaps are not all at same point.
The Kwacker shop manual i have says use a ring compressor!
Any advice on installing the barrels without one?

All parts have arrived so i have a good few hours/days ahead of me in the garage !!
To help work them in by hand, could use chop-sticks, Popsicle sticks, wooden ice-cream spoons, or tongue depressors.

Others may use a strip of metal strap held in position tightly around the rings with a zip-tie, which assembly slides down as the piston enters the cylinder sleeve.

Good Fortune! :)
i found using my freshly manufactured wooden piston holder (as described in Clymer manual, pic attached) and finger nails did the trick... twice as the first time i got the barrels on i realised i forgotten the orange seals underneath each barrel and had to pull them off again .. grrrrrr

Please Log in or Create an account to join the conversation.

  • KZ1000inaus
  • KZ1000inaus's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Luminous Red KZ1000 A2
  • Posts: 135
  • Thanks: 4

Re: Engine rebuild? She lives..

14 Jul 2012 05:52
#535800
rebuilt the engine, fitted the new V&H pipe, set floats, put everything back together.
First touch of the start button and she fired up.
I'm a very happy man. B)

The pipe sounds awesome and she's running very sweet. :cheer:

Gonna clean her up tomorrow and take some pics to post up.

Thanks for all your help and advice guys. :)

Please Log in or Create an account to join the conversation.

  • 650ed
  • 650ed's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 15334
  • Thanks: 2832

Re: Engine rebuild? She lives..

14 Jul 2012 08:14
#535804
I can hear you smiling from here; congrats! Ed
1977 KZ650-C1 Original Owner - Stock (with additional invisible FIAMM horn)

Please Log in or Create an account to join the conversation.

  • Street Fighter LTD
  • Street Fighter LTD's Avatar
  • Offline
  • Moderator
  • Moderator
    Registered
  • TURBO, Its Better to be Blown than Injected
  • Posts: 5192
  • Thanks: 2340

Re: Engine rebuild?

14 Jul 2012 09:00
#535809
See,,,That wasnt so hard :cheer:

Good Job, Enjoy

Original owner 78 1000 LTD
Mr Turbo Race Kit, MTC 1075 Turbo pistons by PitStop Performance , Falicon Ultra Lite Super Crank, APE everything. Les Holt @ PDM's Billet Goodies . Frame by Chuck Kurzawa @ Logghe Chassis . Deep sump 5qt oil pan. RIP Bill Hahn

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum