am i going to loose compression
- cutmesomeslackjk
-
Topic Author
- Offline
- User
-

Registered
- Posts: 38
- Thanks: 0
am i going to loose compression
18 Jun 2008 19:36
it i put a stock head off a late 1980 kz on a 1975 z1 900 engine?
also will everything should bolt up fine?
also will everything should bolt up fine?
1980 kz 1000
with a 1974 z1 900 on it
electronic ignition from 1980
with a 1974 z1 900 on it
electronic ignition from 1980
Please Log in or Create an account to join the conversation.
- PLUMMEN
-
- Offline
- User
-

Registered
- Posts: 7983
- Thanks: 104
Re: am i going to loose compression
18 Jun 2008 19:59
compression wont change.make sure you use the cam sprockets from the old motor since they will be differant than the mkII parts on newer head;)
Still recovering,some days are better than others.
Please Log in or Create an account to join the conversation.
- cutmesomeslackjk
-
Topic Author
- Offline
- User
-

Registered
- Posts: 38
- Thanks: 0
Re: am i going to loose compression
18 Jun 2008 21:51
i dont know witch cam sprockets are witch but i looked at them all (i have 3 sets) and they all looked the same and had the same amount of teeth
1980 kz 1000
with a 1974 z1 900 on it
electronic ignition from 1980
with a 1974 z1 900 on it
electronic ignition from 1980
Please Log in or Create an account to join the conversation.
- larrycavan
-
- User
-

Public
- Thanks: 0
Re: am i going to loose compression
19 Jun 2008 05:13
You may run into exhaust header clamp issues. The 900 had 6mm studs and the 1000 has 8mm. Easy problem to resolve.
You'll have to do something with the exhaust air passages. Also an easy fix.
Flow wise.....same as the 900 unless it's been modified. No real performance gain to be noticed on a stock to stock swap.
Be careful with the valves. If the new head has OEM cast iron valves, do not swap the 900 valves into those guides. You can use a newer valve in an old [bronze] guide but it's not good to go the other way.
You'll have to do something with the exhaust air passages. Also an easy fix.
Flow wise.....same as the 900 unless it's been modified. No real performance gain to be noticed on a stock to stock swap.
Be careful with the valves. If the new head has OEM cast iron valves, do not swap the 900 valves into those guides. You can use a newer valve in an old [bronze] guide but it's not good to go the other way.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
