KZ650 Performance Question - Where's my power?

  • HerrDeacon
  • HerrDeacon's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 642
  • Thanks: 1

KZ650 Performance Question - Where's my power?

19 Oct 2008 08:09
#242604
I have a '78 KZ650SR and I'm wondering about it's power, in particular it's quickness. Mine really doesn't feel very quick. Based on the numbers I see on the net, a stock SR had 62hp and do the quarter mile in the mid 13's. I know my bike is 30 years old and so it probably won't have those numbers but mine doesn't even feel like it's remotely close.

My car is probably a low 15 second car in the quarter mile and it feels soooo much faster than my KZ.

What could be robbing my bike of it's power? Or am I just not riding this bike the correct way to get the power out of it? I recently went for a ride with a '78 CB750 and it was way faster than mine. :S

It's not that I really want to go that fast anyway but I just worry that there may be something wrong with it that I'm just not picking up.

I checked compression and the numbers seem decent:
Dry:
#1 - 160
#2 - 160
#3 - 165
#4 - 170

Wet:
#1 - 170
#2 - 170
#3 - 170
#4 - 170

Also, my intake valves are a bit tight (I'll be fixing these this winter). Can these be affecting performance to this extent?

I have all the maintenace type things taken care of (i.e. carbs sync'd, coil mod, timing, etc).

Any ideas? I've only had this bike for one summer so I don't know the history, is there anything I should check over the winter. I have to reshim the intake valves and also replace the valve seals. Is there anything else I should look for while I'm in there?

Or do I just have too high expectations of my 30 year old bike?

Please Log in or Create an account to join the conversation.

  • OKC_Kent
  • OKC_Kent's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1719
  • Thanks: 21

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 09:45
#242622
Does it have stock size sprockets? If it was set up to cruise it would seem a bit slower
Cashion, OK
78 KZ650 B2 85,000+ miles

Please Log in or Create an account to join the conversation.

  • Mark Wing
  • Mark Wing's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1695
  • Thanks: 22

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 10:35
#242629
Are you running your bike up to the red line when going for it, peek power is at 8,500 rpm on a stock 650 and I spin my hot 650 up to 11,000 all the time. Of course I have cams and heavy duty valve springs a big bore, head work and a pipe Your power is in the upper rpm range.
Mark
Jesus loves you Everyone else thinks your an ***

77 KZ650 C1 with ZX7 forks, GPZ mono rear, wider 18 police wheels and Yoshimura motor.

Yorba Linda Cal.

Please Log in or Create an account to join the conversation.

  • H2RICK
  • H2RICK's Avatar
  • Offline
  • User
  • User
    Registered
  • Is this a fun bike, or what!!!
  • Posts: 662
  • Thanks: 1

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 10:48
#242631
Well, my 650C2 is a rocket....for what it is. Keep in mind it IS a 650, after all, and not a 750 or 900. As posted, you may have a gearing issue. Count your sprocket teeth and we can then see if you've got stock gearing or whatever.
Great compression, BTW, so if your intakes are a "little tight" they can't be out by much, IMO, with those compression numbers you listed.
KZ650C2 Stock/mint. Goes by "Ace".
H2A Built from a genuine basket case. Yes,it's a hot rod.
GT550A Stock/mint. Pleasant stroker.
2006 Bandit 1200S for easy LD rapid transit
Various H2 projects in the wings.

Please Log in or Create an account to join the conversation.

  • HerrDeacon
  • HerrDeacon's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 642
  • Thanks: 1

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 12:47
#242659
Thanks guys, great points. I never thought of the sprockets. I just checked mine: 16T front and 42T rear. I don't know anything about these ratios, are these more for cruising?

Also, Mark brings up a good point. I'm not revving it real high. This is my first street bike and I'm more used to my cars lower rpm sound (my car redlines at 6500 and I usually shift at 5000). I don't think I've ever had the bike much over 6 grand. Just not used to the sound, and think it's time to shift. I'll try going higher.

So, if you were trying to accelerate quickly what RPM are you shifting? Do you do this in all gears, even first and second?

Thanks again.

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 12:51
#242661
The website www.gearingcommander.com covers ratio's and chain speeds on their website. Give them a try. and www.z1enterprises may be able to supply you with different sprockets if changing is what you want.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

  • Mark Wing
  • Mark Wing's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1695
  • Thanks: 22

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 13:08
#242665
That's stock gearing. When going for a run bring it right up to the red line. These motors love to spin. I've missed shifts and pegged the tac with no ill effects.
Jesus loves you Everyone else thinks your an ***

77 KZ650 C1 with ZX7 forks, GPZ mono rear, wider 18 police wheels and Yoshimura motor.

Yorba Linda Cal.

Please Log in or Create an account to join the conversation.

  • timebomb33
  • timebomb33's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 4277
  • Thanks: 10

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 13:33 - 19 Oct 2008 15:04
#242668
with those compression numbers your getting i would say there is nothing wrong with your motor, do as an old french guy told me once[turn the throttle you sob] give that old girl some rpm. these old kawi's love the rpm remember the redline on your tach is just a suggestion. if you compare your bike to a car think of differance between solid lifters and hydralics.solid lifters will always rev harder than hydralics.
1973 z1 2-1974z1-a,2-1975z1-b dragbikes1015cc+1393cc, 1977kz1000,1978kz1000,1981kz1000j, 1997 zx-11, 2000 z12r,1428turbo nitrous pro-mod and a shit load of parts thats all for now leader sask.,CANADA
I THINK MY POWERBAND BROKE
Last edit: 19 Oct 2008 15:04 by timebomb33.

Please Log in or Create an account to join the conversation.

  • HerrDeacon
  • HerrDeacon's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 642
  • Thanks: 1

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 14:38
#242677
timebomb33 wrote:
with those compression numbers your getting i would say there is nothing wrong with your motor, do as an old frech guy told me once[turn the throttle you sob] give that old girl some rpm.

I hope that's all that's wrong with it. I think I'm being too much of a wimp. Just not used to high rpm sound. I just hope I can get a chance to give it a whirl before the winter.

Thanks guys.

Please Log in or Create an account to join the conversation.

  • 77_650B1
  • 77_650B1's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 372
  • Thanks: 0

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 16:03
#242694
Yeah I was out with a buddy who has a 400 seca. All night I was complaining to myself that my bike was too slow, tehn I realized I wasn't going past 5000RPM. So on the way home by myself, I revevd her up to 8 grand. It's a whole different world up that high.
1977 KZ650-B1
-Dual Discs
-Dyna-S
-WG Coil Mod
-Alloy Wheels

Please Log in or Create an account to join the conversation.

  • HerrDeacon
  • HerrDeacon's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 642
  • Thanks: 1

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 17:03
#242705
Can't wait to try it now. :)

My tach says the redline is 9K, is this correct? The reason I ask is that I think the gauges on my bike may be from a different model (different topic :) ), so I just want to confirm what the redline is on an SR.

Please Log in or Create an account to join the conversation.

  • hugo
  • hugo's Avatar
  • Offline
  • User
  • User
    Registered
  • '92 Zephyr 750
  • Posts: 313
  • Thanks: 95

Re: KZ650 Performance Question - Where's my power?

19 Oct 2008 17:11
#242707
Don't compare a bigger car engine with a much smaller bike engine when it comes to revs. Mostly, what limits RPM is the weight of the piston and the stroke. My Mitsubishi 1.8 liters has a bore and stroke of 81mm x 89 mm (undersquare) and is redlined at 6,000 revs. My Zephyr 750 has 66mm x 54 mm (oversquare) and is redlined a 10,000 rpm. In other words, the much smaller ligther pistons plus the much less travel, allow much higher revs without inducing heavy pounding on the crank.

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum