R.C. Engineering 400 Cams

  • 89LX
  • 89LX's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 26
  • Thanks: 0

R.C. Engineering 400 Cams

02 Dec 2008 08:35
#250354
Does anyone know where I can get the specs on an old set of cams I have?

They are R.C. Engineering 400 cams. Back in the day, I was told that the 400 and 415 cams were the same.

I would like to "degree" the cams in rather than just lining up the timing marks.

Contacted R.C., but they were no help.
1977 KZ650B1
Overbored to 66mm in '79 w/ Venolia pop-up pistons & RC400Pro Cams
Restoration in process.....

Please Log in or Create an account to join the conversation.

  • APE Jay
  • APE Jay's Avatar
  • User
  • User
    Public
  • Thanks: 0

Re: R.C. Engineering 400 Cams

02 Dec 2008 14:03
#250411
.424 Lift , set to 108 lobe centers. Int open 19.5 BTDC closes 55.5 ABDC
Exhaust, opposite.

I think I have a brand new set of those around here somewhere.

Jay

Please Log in or Create an account to join the conversation.

  • 89LX
  • 89LX's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 26
  • Thanks: 0

Re: R.C. Engineering 400 Cams

02 Dec 2008 14:15
#250413
Excellent sir.

Thanks.

One more thing. Do you know what kind of duration those have? Seemed like a lot......
1977 KZ650B1
Overbored to 66mm in '79 w/ Venolia pop-up pistons & RC400Pro Cams
Restoration in process.....

Please Log in or Create an account to join the conversation.

  • APE Jay
  • APE Jay's Avatar
  • User
  • User
    Public
  • Thanks: 0

Re: R.C. Engineering 400 Cams

02 Dec 2008 14:30
#250414
Yes. RC used to use what was called, advertised duration". It was a figure taken at only .010 0r .020" to make it sound like a lot.

The catalog shows. 310 degrees. Just ignore that and the open and close figures I posted, and just degree them at .050" to 108.

Lash is shown as .004" intake and .006" exhaust.

Please Log in or Create an account to join the conversation.

  • 89LX
  • 89LX's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 26
  • Thanks: 0

Re: R.C. Engineering 400 Cams

03 Dec 2008 04:26
#250477
Great!!

Thanks again for all of the help!!
1977 KZ650B1
Overbored to 66mm in '79 w/ Venolia pop-up pistons & RC400Pro Cams
Restoration in process.....

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum