cam end caps
- mark1122
-
- Offline
- User
-

Registered
- Keep twisting it
- Posts: 5297
- Thanks: 109
Re: cam end caps
22 Jan 2012 09:42
[quote="Breaker19" post=498141 I am finding a trickle of oil (when it's level on the center-stand for awhile), can't exactly nail it down, but I am guessing it's from the end bolt that is not a dead-end thread, but comes through. Did you guys put sealant on that bolt thread? Thanks.[/quote]
yes i have had the same problem . i cured it by adding a dab of permatex to the threads before installing those through bolts.
yes i have had the same problem . i cured it by adding a dab of permatex to the threads before installing those through bolts.
76 KZ, frame gusset work,1200CC.Ported by Larry Cavanaugh, 1.5mm.over intakes, Carron Pipe, ZRX12 rear end, and seat,96zx9 front end.
01 CBR600F4i Track bike.
Cobourg, Ont. Can.
~ ~ ~_@
~ ~ _- \,
~ (k) / (z)
01 CBR600F4i Track bike.
Cobourg, Ont. Can.
~ ~ ~_@
~ ~ _- \,
~ (k) / (z)
Please Log in or Create an account to join the conversation.
- Breaker19
-
- Offline
- User
-

Registered
- Posts: 88
- Thanks: 2
Re: cam end caps
22 Jan 2012 18:20mark1122 wrote: [quote="Breaker19" post=498141 I am finding a trickle of oil (when it's level on the center-stand for awhile), can't exactly nail it down, but I am guessing it's from the end bolt that is not a dead-end thread, but comes through. Did you guys put sealant on that bolt thread? Thanks.
yes i have had the same problem . i cured it by adding a dab of permatex to the threads before installing those through bolts.[/quote]
I ended up doing them over, it took only a couple minutes to yank the tank and pull the valve cover of, so when I checked, it appears I put some blue gasket goo but not much... so, I cleaned each mating surface and the rubber itself with a small amount of carb cleaner on a rag, carefully lifted up the gasket on the ends (my new gasket decided to stick pretty hard!) and applied a good amount of black permatex ultra in the half-round hole and where the joint will be between the plug and the head. Then, put all the bolts back in with some permatex on the end bolts too. I didn't even wait overnight, I waited about 4-5 hours and took it out on a ride. No leaks. Rode 135 miles yesterday, still no leaks. Thanks for the tips.
2003 Suzuki DR650 Dual-Sport
1982 KZ1100A2 - GONE! Traded-in for a '12 Concours 14
www.facebook.com/pages/Moto-Resto/169238286503527
1982 KZ1100A2 - GONE! Traded-in for a '12 Concours 14
www.facebook.com/pages/Moto-Resto/169238286503527
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
