Strange oil leak?
- polkat
-
Topic Author
- Offline
- User
-

Registered
- Posts: 513
- Thanks: 1
Strange oil leak?
19 Jan 2010 22:47 - 19 Jan 2010 22:50
Recently when I park my 1982 KZ750H3 after riding, I notice that there is fresh oil leaking down the left side of the engine in front of the alternator cover. Here....
(the image is just one I grabbed off the web as my camera bats are dead)
It doesn't appear to be coming from the cam cover above or to be under any pressure. It seems to be coming from the junction of the bottom of that cylinder and the case. I plan to rebuild the engine next summer, but I am wondering of I can put some kind of sealant (maybe hi-temp silicon) in there as a temporary fix?
Any ideas?
(the image is just one I grabbed off the web as my camera bats are dead)
It doesn't appear to be coming from the cam cover above or to be under any pressure. It seems to be coming from the junction of the bottom of that cylinder and the case. I plan to rebuild the engine next summer, but I am wondering of I can put some kind of sealant (maybe hi-temp silicon) in there as a temporary fix?
Any ideas?
Last edit: 19 Jan 2010 22:50 by polkat.
Please Log in or Create an account to join the conversation.
- RonKZ650
-
- Offline
- User
-

Registered
- Posts: 3719
- Thanks: 252
Re: Strange oil leak?
20 Jan 2010 06:37
KZ650/750 are full of rubber orings. There's rubber orings that seal the cylinder to the block where the oil passages go up each side. My guess is the rubber rings have hardened and started leaking. You can use silicon possibly. I've done it and it's kind of a mess, but does the trick for a while at least.
321,000 miles on KZ's that I can remember. Not going to see any more.
Please Log in or Create an account to join the conversation.
- Bluemeanie
-
- Offline
- User
-

Registered
- Posts: 2516
- Thanks: 15
Re: Strange oil leak?
21 Jan 2010 06:00
RonKZ650 wrote:
Use some brake clean (evaporates) and clean it real nice, go for a short ride and when you get back you should see exactly where it's coming from. Clean again and apply with your finger some good (usually "black" silicon is oil resistant) quality silicon along seam line 1-2 inches on either side of leak. Remove excess and let sit overnight and it should hold for quite a while. Can easily be reapplied if necessary to hold until re build.
KZ650/750 are full of rubber orings. There's rubber orings that seal the cylinder to the block where the oil passages go up each side. My guess is the rubber rings have hardened and started leaking. You can use silicon possibly. I've done it and it's kind of a mess, but does the trick for a while at least.
Use some brake clean (evaporates) and clean it real nice, go for a short ride and when you get back you should see exactly where it's coming from. Clean again and apply with your finger some good (usually "black" silicon is oil resistant) quality silicon along seam line 1-2 inches on either side of leak. Remove excess and let sit overnight and it should hold for quite a while. Can easily be reapplied if necessary to hold until re build.
1980 KZ650F1, Bought new out the door for $2,162.98!
Please Log in or Create an account to join the conversation.
- Kawickrice
-
- Offline
- User
-

Registered
- After Monday & Tuesday, even the calendar says WTF
- Posts: 2469
- Thanks: 20
Re: Strange oil leak?
21 Jan 2010 06:55
Could it possibly be coming from the grommet at the bottom of the cover where the wires for the stator exit the cover? I have found that an aerosol foot powder works great to find leaking gaskets. Clean the motor and spray it on suspect areas, then take a short ride, it will highlight the leak.
73 Kawasaki Z1
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
Please Log in or Create an account to join the conversation.
- JMKZHI
-
- Offline
- Platinum Member
-

Registered
- Posts: 2417
- Thanks: 48
Re: Strange oil leak?
21 Jan 2010 07:29
Kawickrice wrote:
The grommet is on the lower rearward side. I don't believe the 750H should have oil behind the that cover.Could it possibly be coming from the grommet at the bottom of the cover where the wires for the stator exit the cover? ...
Please Log in or Create an account to join the conversation.
- polkat
-
Topic Author
- Offline
- User
-

Registered
- Posts: 513
- Thanks: 1
Re: Strange oil leak?
21 Jan 2010 12:29
No, it's not coming from the bottom grommet, it's where I indicated in the pic. But it's not flowing out from there but from somewhere above. That's why I assume it's coming from the junction of the cylinders and case. I've had the alternator cover off before and it's dry inside is JMKZHI thought. I'll try the cleaning/silicon idea.
Please Log in or Create an account to join the conversation.
- gane
-
- Offline
- User
-

Registered
- Posts: 706
- Thanks: 1
Re: Strange oil leak?
21 Jan 2010 18:47
Ever the optomist, By all means, clean & dry before searching further. If cam cover is dry, possible culprets are base gsk/head gsk, BUT! another is possible and should be checked before bumming.... Cam chain tensioner/gsk. could be source. the air passages thru head can allow weeps from this area to flow down, run along fins & drip to this area. after clean/dry, re-inspect, in cases where source is hard to find, ARID EXTRA DRY deoderant is a handy tool. spray liberally, It leaves a dry powdery residual. well everywhere! but cleans up easily, & will at least help find source..Luck G
[img][/img] 1977 KZ1000A1
Please Log in or Create an account to join the conversation.
- polkat
-
Topic Author
- Offline
- User
-

Registered
- Posts: 513
- Thanks: 1
Re: Strange oil leak?
21 Jan 2010 22:20
Yes, the cylinder fins are oily on that side, but I don't see any flow there while the engine is running. I only actually see it flowing where I mentioned. It's not a leak under pressure but rather a slow flow.
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: Strange oil leak?
22 Jan 2010 04:58
Would also assure that an exhaust header clamp nut hasn't loosened. And if applicable that there's no loose oil cooler hose fitting.
I prefer the foot spray because it seems to contain more power residue.
While at it, after cleaning engine and allowing to dry, would also spray around all usual suspects (cam plugs, valve cover gasket, head gasket, tach drive, exhaust clamps, base gasket).
Then crank and run the clean freshly powdered engine for a few moments to detect the seepage areas.
Good Luck!
I prefer the foot spray because it seems to contain more power residue.
While at it, after cleaning engine and allowing to dry, would also spray around all usual suspects (cam plugs, valve cover gasket, head gasket, tach drive, exhaust clamps, base gasket).
Then crank and run the clean freshly powdered engine for a few moments to detect the seepage areas.
Good Luck!
1973 Z1
KZ900 LTD
KZ900 LTD
Please Log in or Create an account to join the conversation.
- Kawickrice
-
- Offline
- User
-

Registered
- After Monday & Tuesday, even the calendar says WTF
- Posts: 2469
- Thanks: 20
Re: Strange oil leak?
22 Jan 2010 07:05
Does that bike have the tach drive on the head above the exhaust? Mine leaked and would blow to the sides from the wind and then drip. Clean the area then spray an aerosol foot powder in the area then start it up. The white foot powder will highlight the leak.
73 Kawasaki Z1
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
Please Log in or Create an account to join the conversation.
- Old Man Rock
-
- Offline
- User
-

Registered
- Posts: 6071
- Thanks: 225
Re: Strange oil leak?
22 Jan 2010 07:12
OK, have to ask the stupid qiuestion of the day...
Actually 2.... :blush:
Torques on the cylinder stud nuts and in this case, the side bolt in the image between the 2 cylinder studs have been checked/tightened/confirmed?
Is the oil leak coming for that side bolt... Clean oil is hard to detect. I had similar in my new engine build... Once I got some miles on the engine, Dyno oil at the time darkened and this is where is was coming from...
NOTE: On new builds, this is somehwat expected where bolts loosen... As provided to me... 50-500-1000 mile checks, torque every single bolt on the engine and frame to torque specs....
Just a thought....
OMR
Actually 2.... :blush:
Torques on the cylinder stud nuts and in this case, the side bolt in the image between the 2 cylinder studs have been checked/tightened/confirmed?
Is the oil leak coming for that side bolt... Clean oil is hard to detect. I had similar in my new engine build... Once I got some miles on the engine, Dyno oil at the time darkened and this is where is was coming from...
NOTE: On new builds, this is somehwat expected where bolts loosen... As provided to me... 50-500-1000 mile checks, torque every single bolt on the engine and frame to torque specs....
Just a thought....
OMR
1976 KZ900-A4
MTC 1075cc.
Camshafts: Kawi GPZ-1100 .375 lift
Head: P&P via Larry Cavanaugh
ZX636 suspension
MIKUNI, RS-34'S...
Kerker 4-1, 1.5" comp baffle.
Dyna-S E.I.
Earls 10 row Oil Cooler
Acewell 2802 Series Speedo/Tach
Innovate LC1 Wideband 02 AFR meter
Phoenix, Az
MTC 1075cc.
Camshafts: Kawi GPZ-1100 .375 lift
Head: P&P via Larry Cavanaugh
ZX636 suspension
MIKUNI, RS-34'S...
Kerker 4-1, 1.5" comp baffle.
Dyna-S E.I.
Earls 10 row Oil Cooler
Acewell 2802 Series Speedo/Tach
Innovate LC1 Wideband 02 AFR meter
Phoenix, Az
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
