Parts needed after splitting the cases?
- retterath
-
Topic Author
- Offline
- User
-

Registered
- Posts: 99
- Thanks: 9
Parts needed after splitting the cases?
01 May 2010 11:36
I'm about to split the cases on my '80 kz750e, and want to have all the parts on hand so I can do the repair with minimal time spent apart on the bench.
I have a broken output shaft (chain too tight :blush: ), so I picked up a complete gear set, a factory manual, and a nearly complete parts bike as a last resort, but I need to know what gaskets, etc. I will likely need to do this right.
Thanks in advance.
Retterath
I have a broken output shaft (chain too tight :blush: ), so I picked up a complete gear set, a factory manual, and a nearly complete parts bike as a last resort, but I need to know what gaskets, etc. I will likely need to do this right.
Thanks in advance.
Retterath
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: Parts needed after splitting the cases?
01 May 2010 12:01 - 01 May 2010 12:03
Depending on mileage, you probably would want to change the cam chain. Maybe the main bearing shells too. You will need a full rebuild gasket set. Vesrah is pretty good, I had very bad luck with Athena gaskets.
1979 KZ-750 Twin
Last edit: 01 May 2010 12:03 by bountyhunter.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
