Piston and Cylinder Bore
- Brown Bear
-
Topic Author
- Offline
- User
-

Registered
- Posts: 74
- Thanks: 0
Piston and Cylinder Bore
13 Aug 2010 08:38
the KZ550
Piston OD 57.80mm
Bore 58.10mm
KZ400
piston OD approx 52mm
too much of a difference i think..
Piston OD 57.80mm
Bore 58.10mm
KZ400
piston OD approx 52mm
too much of a difference i think..
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: Piston and Cylinder Bore
13 Aug 2010 11:14
Where did you measure piston diameter? They are always narrower at the top and wider at the bottom. I recall at the top where the rings are, there is about a .006" gap to the cylinder wall.
1979 KZ-750 Twin
Please Log in or Create an account to join the conversation.
- Brown Bear
-
Topic Author
- Offline
- User
-

Registered
- Posts: 74
- Thanks: 0
Re: Piston and Cylinder Bore
13 Aug 2010 12:10
not far from the bottom, i also looked in the manual. which says pretty much the same
Please Log in or Create an account to join the conversation.
- steell
-
- Offline
- User
-

Registered
- Posts: 6849
- Thanks: 208
Re: Piston and Cylinder Bore
13 Aug 2010 12:40
bountyhunter wrote:
And wider measured across the pin than perpendicular to the pin.
Makes for an odd shape piston when you think about it.
Just measured a Wiseco 810 piston to verify.
Where did you measure piston diameter? They are always narrower at the top and wider at the bottom. I recall at the top where the rings are, there is about a .006" gap to the cylinder wall.
And wider measured across the pin than perpendicular to the pin.
Makes for an odd shape piston when you think about it.
Just measured a Wiseco 810 piston to verify.
KD9JUR
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
