Ignition Timing?

  • Fastdave61
  • Fastdave61's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 31
  • Thanks: 0

Ignition Timing?

23 Mar 2011 21:53
#440015
I have been working all winter on my '80 KZ1000G (fuel injected) Not a restoration but maybe a refurbishment. New tires, chain & sprokets, and top end. So today I finally finished it, poured gas in the tank, backed it off the lift, opened the shop door and was ready to hear some music. I turned the key on, pulled in the cluch lever, hit the starter button, nothing. The engine turns over freely, I have gas and spark. (but probably not at the right time) It just kind of gurgles through the exhaust. My guess is timing, although I was very careful to get the timing right when I put the engine back together, I must be 360 degrees off. Any comments or help would be appreciated. :(
1969 BSA A65F Firebird
2004 BMW R1150RT
1980 Kz1000G1
2008 Triumph Tiger 1050
Bemidji, Mn

Please Log in or Create an account to join the conversation.

  • Krusty_47
  • Krusty_47's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 107
  • Thanks: 0

Re: Ignition Timing?

23 Mar 2011 22:04 - 23 Mar 2011 22:06
#440016
I think you mean 180 degrees off. I don't think that's it. I would thing that either 1 of 2 things.
1. You plugged the spark plugs up to the wrong Coils. Left side is 1 and 4 cylinders. Those are the outside ones. 2 and 4 are on the right.
2. You incorrectly hooked up the points. Try swapping those if the above is correct.

Although it could be your cams not being right.

I have the same bike as you and that's my next project. I plan on doing a full factory restoration of the bike. Hopefully this current project will only take me about 6 months.
1976 KZ900 A4
1980 KZ1000 G1
Last edit: 23 Mar 2011 22:06 by Krusty_47.

Please Log in or Create an account to join the conversation.

  • Fastdave61
  • Fastdave61's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 31
  • Thanks: 0

Re: Ignition Timing?

23 Mar 2011 22:15
#440020
Krusty, Thanks for the reply, yes I mean 180 degrees. And yes it could be the plug wires, I know that the left coil is 1&4 and the right is 2&3. I wish I'd have marked the wires but I didn't and I think I have them right. As for the points, the G has electronic ignition.
1969 BSA A65F Firebird
2004 BMW R1150RT
1980 Kz1000G1
2008 Triumph Tiger 1050
Bemidji, Mn

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: Ignition Timing?

23 Mar 2011 22:16
#440021
I believe your bikes have/had a resistor bank to reduce the current to the ignition coils. I'd check there for broken resistors or solder connections. I'd also think you could run 3 ohm coils by eliminating the resistors.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

  • Krusty_47
  • Krusty_47's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 107
  • Thanks: 0

Re: Ignition Timing?

23 Mar 2011 22:21
#440023
Did you remove the coils when you took out the engine? If so you might have put them in and hooked them up backwards. Try swapping the 1 and 2 and 3 and 4 and see what happens.
1976 KZ900 A4
1980 KZ1000 G1

Please Log in or Create an account to join the conversation.

  • Fastdave61
  • Fastdave61's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 31
  • Thanks: 0

Re: Ignition Timing?

24 Mar 2011 00:07
#440056
Didn't take the engine out and didn't remove the coils. It ran (not very well) before I did the top end.
1969 BSA A65F Firebird
2004 BMW R1150RT
1980 Kz1000G1
2008 Triumph Tiger 1050
Bemidji, Mn

Please Log in or Create an account to join the conversation.

  • Fastdave61
  • Fastdave61's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 31
  • Thanks: 0

Re: Ignition Timing?

24 Mar 2011 20:14
#440203
Krusty: I'm going to replace the coils and eliminate the resistors. I'm sure the timing is correct as I was very meticulous when I put the top end back together. Good luck with your restoration.
1969 BSA A65F Firebird
2004 BMW R1150RT
1980 Kz1000G1
2008 Triumph Tiger 1050
Bemidji, Mn

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum