still won't start
- yogibear
-
Topic Author
- Offline
- User
-

Registered
- meangreen
- Posts: 4
- Thanks: 0
still won't start
05 Apr 2011 23:46
i have checked the plugs ,they were badly fouled i cleaned them ,checked the gaps were all good,put one on the head nice blue spark on all cylinders, so i have fire, it seems like when i turn the fuel on it floods maybe a float issue the floats are bent it has compression also 115 to 118 across the cylinders any clues
79 kz1000e
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: still won't start
05 Apr 2011 23:51
Checked the valve clearances? 115-118 is really low for an engine to run. When new/rebuilt it might be 180 or more, as the engine gets years/miles it might go down to 160 or so.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- jjack010
-
- Offline
- User
-

Registered
- Posts: 42
- Thanks: 3
Re: still won't start
05 Apr 2011 23:52
Inspect floats and float level.
1974 Kawasaki Z1
Central Texas
Central Texas
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: still won't start
06 Apr 2011 00:27yogibear wrote: i have checked the plugs ,they were badly fouled i cleaned them ,checked the gaps were all good,put one on the head nice blue spark on all cylinders, so i have fire, it seems like when i turn the fuel on it floods maybe a float issue the floats are bent it has compression also 115 to 118 across the cylinders any clues
Per FSM, standard compression is 128~156 psi with service limit of 100 psi and less than 14 psi difference between the cylinders.
If not already doing, remember to hold throttle wide open during the compression test.
Meanwhile, until resolving the flooding issue, would sniff-test the crankcase oil and examine its physical quality to determine whether gasoline has entered the crankcase and contaminated the oil.
And if so, should change both oil and filter, and not allow any more gasoline into the carbs (safest method is to remove fuel line at the petcock.)
Am wondering if maybe one or more of the carb overflow circuits is obstructed. Excess fuel getting past the float valve (for whatever reason) is supposed to escape via the overflow circuit and exit through a hose routed underneath the bike.
Good Fortune!
1973 Z1
KZ900 LTD
KZ900 LTD
Please Log in or Create an account to join the conversation.
- yogibear
-
Topic Author
- Offline
- User
-

Registered
- meangreen
- Posts: 4
- Thanks: 0
Re: still won't start but i figured it out
07 Apr 2011 19:48
when i had the carbs apart the last time i lost the float needle and didn't notice it gone.
i bought new floats and just put in for new float needles should be running shortly
i bought new floats and just put in for new float needles should be running shortly
79 kz1000e
Please Log in or Create an account to join the conversation.
- TreeClimber
-
- Offline
- User
-

Registered
- Posts: 5
- Thanks: 0
Re: still won't start but i figured it out
08 Apr 2011 00:22
im having troubles starting as well. checked my fuel level in the bowl today and it is within spec. needles seat well and everything is all cleaned out in the carb. on and prime settings on petcock both working properly.
All i can get is a few kicks of the engine. just a few pops of ignition... im stumped at this point.
All i can get is a few kicks of the engine. just a few pops of ignition... im stumped at this point.
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: still won't start but i figured it out
08 Apr 2011 00:50
Good spark? Good compression? Air filter clean? No rust in the tank?
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- jjack010
-
- Offline
- User
-

Registered
- Posts: 42
- Thanks: 3
Re: still won't start but i figured it out
08 Apr 2011 22:25
Treeclimber, sounds like timing.
1974 Kawasaki Z1
Central Texas
Central Texas
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
