nightmare part 8

  • Motor Head
  • Motor Head's Avatar
  • Offline
  • User
  • User
    Registered
  • FIX UP YOUR BIKE RIGHT AND CHEAP
  • Posts: 5137
  • Thanks: 393

Re: nightmare part 8

11 Apr 2011 13:17 - 11 Apr 2011 13:24
#444071
Sorry I though I read that you had PODs in your previous posting.
If your carbs are jetted as per factory, then it sounds like intake vacuum leak. All 4 hose nipples on the manifolds either must be plugged or if stock there should be lines on 3. #1&4 will hook together in a Tee, going to the Air Valve under the tank. #2 would go to the vacuum petcock at the tank.
Are you sure the manifolds aren't broken/ cracked leaking vacuum?
Also be completely sure that the diaphragms are not cracked/ holes in them. A good test is to hold a finger over the hole in the bottom of the slide, while the slide is held up at the top of its travel. Should hold there as only slight finger pressure to plug the hole remains. Hole must be referenced to the front, Intake/ Motor side of carb. Vacuum lifts the slide, any leaks and slide will not lift, lean city.
Here is the carb and list from Kawasaki.
1982 KZ1000LTD K2 Vance & Hines 4-1 ACCEL COILS Added Vetter fairing & Bags. FOX Racing rear Shocks, Braced Swing-arm, Fork Brace, Progressive Fork Springs RT Gold Emulators, APE Valve Springs, 1166 Big Bore kit, RS34's, GPZ cams.
1980 KZ550LTD C1 Stock SOLD Miss it
1979 MAZDA RX7 in the works, 13B 6 port built/ light flywheel/ 48 DCO Weber LUV IT! Street Legal Go Cart!
1982 KZ1100 A-2 Shaft just bought it in pieces form 1st owner: Now Running Great! SOLD
1990 Concours 1000 Project bike rough body work: Now Running & Riding!
www.kz1000r.com/downloads/Kawasaki%20KZ1...Service%20Manual.pdf
Last edit: 11 Apr 2011 13:24 by Motor Head.

Please Log in or Create an account to join the conversation.

  • Beard
  • Beard's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 74
  • Thanks: 0

Re: nightmare part 8

11 Apr 2011 16:47
#444100
martin_csr wrote: filter, add fresh fuel 87 octane.

i think i read on here before... but search is providing nothing..
just was recently telling a friend people had their reasonings for running low octane in older bikes..

or is this just another 9mm vs .45 camaro vs firebird situation?
79 KZ650B
Jack of everything, Master of nothing.

Please Log in or Create an account to join the conversation.

  • DoubleDub
  • DoubleDub's Avatar
  • User
  • User
    Public
  • Thanks: 0

Re: nightmare part 8

11 Apr 2011 17:22
#444106
Higher compression requires higher octane. Most of these older bikes have relatively low compression compared to new bikes. Extra octane is not always necessary. However, if you are trying to avoid corrosive fuel that absorbs water you may need to look at the higher octane fuels that don't have Ethanol in them.

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum