Problem Cylinder

  • ed spangler
  • ed spangler's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Tennessee Z
  • Posts: 512
  • Thanks: 29

Problem Cylinder

25 Apr 2011 14:00
#446950
75 Z1B 900, 58K miles on bike, problem is I have one cylinder that does not want to "Light" WHEN i start the bike, happens about 50% of the time if the bike has been run within a week or 2, if bike has sat for month or more when the bike is started, we take a laser heat detector and point at header pipes, 3 will be hot one not, if you are sitting on the bike the one on riders far left ( Outside cylinder), can pull the plug and it will be gas fouled, carefully heat plug w/ propane torch to burn off excess fuel and about 50% of the time it will "Light", rest of time pull a plug from one of the 3 that is running good put that plug in the problem cylinder and 100% of the time will "Light" and you can ride 50 miles or 250 and bike runs really great! Can shut bike off for 30 minutes at stop for coffe tec. and bike will fire right back up on all 4 cylinders and run great, .....BTW Bike has new coils, new plug wires, boots, new plugs, valves have been adjusted,Cam Chain Adjusted, cleaned petcock, new fuel lines, timing set, carbs adjusted etc. etc. Is this just one of the things about the stock type coils? ( ... Has new points and condensers also and padvance mechanism has been taken apart ,cleaned, litely lubricated and is working fine )) Do I need to think about converting to Electronic Ignition? Is there a "Resister" somewhre in the circuitry that could cause the spark to be weak? Seems to be a "Spark" problem and it does get irritating to have to pull plugs swap plugs, check w/ Laser Heat Detector to mae sure all cyls are lit, etc. to go for a ride.
Any Thoughts anyone? Yep, its always same cylinder.
Thanks
ED
Have 1975 Kawasaki Z1-B & 2003 Harley Davidson Heritage Softail Classic
Had Hondas, Harleys and many ,many Z Series Kaws both Std. & LTD's

Please Log in or Create an account to join the conversation.

  • bountyhunter
  • bountyhunter's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 7245
  • Thanks: 338

Re: Problem Cylinder

25 Apr 2011 15:31 - 25 Apr 2011 15:33
#446963
Sounds like you have a problem with that one which is fouling the plug. You have one coil working two plugs in series, so a bad coil would likely cause two plugs not to be firing, not just one plug.

Did you check compression on that cylinder?

Check spark with plug out and touching the head? If you get a good spark, it's not the coil.

Not firing could be low compression, carb problem, or (on mine) a bad valve seal let oil seep down and foul the plug.
1979 KZ-750 Twin
Last edit: 25 Apr 2011 15:33 by bountyhunter.

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum