Exhaust Opinion!

  • badrhino
  • badrhino's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 554
  • Thanks: 6

Exhaust Opinion!

04 May 2011 14:53
#448842
Finally getting the bike ready and need some input. My exhaust is a Vance and Hines 4-into-1 and it has some rust on inside of down tubes and some rash/rust on the bottom collector and rear of silencer/megaphone outlet (apparently it had been dropped). Just wondering what I should do to clean it up. I am going with the blacked out theme mostly on the bike. Can a guy have it blasted/smoothed up and powder coated? Or should I just use some heat wrap and cut off about 3-4 inch of the silencer and us it as is. Any other suggestions welcome.B)
1980 KZ1000 with a 1982 KZ1000J motor with 1100 pistons and heads, Vance & Hines, 29MM Smooth Bores, Work in Progress
Franken Z!

Please Log in or Create an account to join the conversation.

  • Tyler
  • Tyler's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 845
  • Thanks: 92

Re: Exhaust Opinion!

04 May 2011 15:37 - 04 May 2011 15:39
#448855
Just bead blast it to remove any loose chrome and rust, then paint. I used the ceramic stuff called VHT. Others have used black paint for BBQ grills with good results as well.

Avoid heat wrap unless you really want to use it. It traps moisture and greatly increases the temperature of the exhaust tubes, it will rust them out over time.
If I knew what I was doing all the time life wouldn't be any fun.

'80 KZ650 E 700cc, dyna ignition and coils, frame up restoration, daily driver
'81 KZ1300 A3 full restoration, custom big bore pistons, 1400cc 6 cylinder super bike
"77 KZ650 B1 - Barn Find, work in progeress
"74 Yamaha DT 400 Enduro
Last edit: 04 May 2011 15:39 by Tyler.

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum