bike won't fire up..!
- GabeKZ400
-
Topic Author
- Offline
- User
-

Registered
- Posts: 3
- Thanks: 0
bike won't fire up..!
04 May 2011 21:14
ok..I gave a kz400 that had electric work done already. i cleaned out the tank...cleaned the carb. but the bike will not fire. it does turn just won't completely start. i even tried push starting it but it just won't grab. it is getting fuel also. any ideas what I can do to get it going. I'm tired of driving a truck.
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: bike won't fire up..!
04 May 2011 21:48
To start the engine, the run/stop switch must be on,the ignition switch on and the clutch lever squeezed and then the start switch pushed.
If no luck, get a multimeter and check for battery voltage on the primary(small wires side of the ignition coil(s). The RED probe will need to touch where the red wire goes to the coil(s) with the BLACK probe at either the battery negative terminal,or a good frame ground(like the engine bolt where the Negative battery cable goes).
If no coil voltage, start by going back through the switches looking for battery voltage.Is the battery is fully charged?
If no luck, get a multimeter and check for battery voltage on the primary(small wires side of the ignition coil(s). The RED probe will need to touch where the red wire goes to the coil(s) with the BLACK probe at either the battery negative terminal,or a good frame ground(like the engine bolt where the Negative battery cable goes).
If no coil voltage, start by going back through the switches looking for battery voltage.Is the battery is fully charged?
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
