need help with a starting issue.

  • edgaro
  • edgaro's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 2
  • Thanks: 0

need help with a starting issue.

17 May 2011 00:56
#451637
hello all I have been frequenting your forum for about 2 months now. I dont post just mainly lurk and try to learn. well I finally have an issue.
I bought a 78 kz750 about a month ago that was not running.
I have repaired the wiring harness that was burned in certain places, rebuilt the carburetors. new fuel lines and filters, new coil boots and plugs, new ignition points set the gap and timing. new brake pads front and rear rebuilt both master cylinders.
So the last thing to do was do an oil change went and bought a filter and picked up some castrol gtx 10w 40. well i did the oil change and went for a drive of about 60 miles. On the way home I stopped to top up. Went to start the bike, hit the electric start and the starter sounded like it was just freespinning. hit it again and same thing. so I resorted to the kickstart to get it running. it took a bit to get it started. today I swapped out the starter for another one I had that I know is good. and same thing just freespinning. I can feel that the chain seems to be moving under the cover.

Would the oil cause the starter clutches to slip? I am thinking i need to drain the oil and go with motorcycle oil like i should of done.
any help appreciated?

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: need help with a starting issue.

17 May 2011 01:06
#451638
Some if not all car rated oils have friction modifiers in them. This is due to the EPA mandating the gas mileage of newer cars.

The commercial grade oils are clearly superior to the mass market oils. For the best protection in your bike or car, use Shell Rotella Synthetic, available at Wal-Mart in blue containers . For the best petroleum oil you can buy, get Shell Rotella T, Mobil Delvac 1300, or Chevron Delo 400, available at any auto parts store. On the back of most oil cans is a circular stamp with the certification. Avoid oils that say "energy conserving" in the bottom half of the donut. These oils contain friction modifier additives that could cause clutch slipping over time. All XXw-20 and XXw-30 oils are energy conserving, and should not be used in your motorcycle. Don't buy any oil additives like STP or Slick-50.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

  • edgaro
  • edgaro's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 2
  • Thanks: 0

Re: need help with a starting issue.

17 May 2011 01:08
#451639
thanks for the quick reply.
So does this sound like something that would happen with oil with friction modifiers?
I am going tomorrow to get some oil. just hoping I dont have to replace the clutches.

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: need help with a starting issue.

17 May 2011 01:35
#451642
I doubt if your drive cluch or the starter motor roller clutches need replacing, just change the oil and go for a ride.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: need help with a starting issue.

17 May 2011 01:37
#451644
If the starting motor clutch is worn, www.z1enterprises.com sells new springs, rollers and other parts for these older bikes.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum