Starting problems

  • darkside161
  • darkside161's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 4
  • Thanks: 0

Starting problems

26 May 2011 20:42
#453758
I have a 75 Z1 900 and it was running fine about 2 months ago. I let it sit covered outside for those 2 months and went to start it today and it cranked over and ran for about 30 seconds before it died. I had just replaced the head lamp and was checking the high beam and low beam as well as the signals when it died on me. I don't know if it is an electrical issue or an engine issue. I bought the bike from a friend and it had been sitting for about 25 years getting ran "every once in awhile", but I ran it all last summer and on a few warm days in March this year with no problems. Any help is appreciated. I am still new to these machines and it is my first bike so it maybe a rookie mistake that I don't know about.

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: Starting problems

26 May 2011 20:49
#453764
Was it parked with gas in the tank? If so, I suspect the fuel system will need a good cleaning(tank,petcock, & carbs).

How's the spark look? A nice blue, fat spark. or weak?
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

  • darkside161
  • darkside161's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 4
  • Thanks: 0

Re: Starting problems

26 May 2011 20:55
#453765
Spark is good, changed them last spring. I filled it up with high test gas last time I rode it. I thought that might be an issue, but I didn't think 2 months would be long enough for fuel to start going bad. I also run a little sea foam in every tank.

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: Starting problems

26 May 2011 23:51
#453798
Would assure valve clearances are within specs.
If too tight, may fail to seal as engine attains normal operating temperature.

Good Fortune! :)
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: Starting problems

26 May 2011 23:53
#453800
Some other possibilities might include a blown fuse, or a bad battery, or imperfect battery cable connections. :)
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

  • darkside161
  • darkside161's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 4
  • Thanks: 0

Re: Starting problems

27 May 2011 00:00
#453802
I guess this is electrical then. My starter won't turn and my light panel does not shine anymore and I have had to use the kick start to get to go. Thanks for the info and I will change the battery and see what that does for me.

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: Starting problems

27 May 2011 00:09
#453803
darkside161 wrote: I guess this is electrical then. My starter won't turn and my light panel does not shine anymore and I have had to use the kick start to get to go. Thanks for the info and I will change the battery and see what that does for me.

Would also assure integrity of the connection where the negative battery cable attaches to rear of the engine.

Good Fortune! :)
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

  • darkside161
  • darkside161's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 4
  • Thanks: 0

Re: Starting problems

27 May 2011 00:34
#453810
Okay, I will check the cables as far as where they go, I guess I am looking for a bad or corroded cable. I have been keeping the battery clean with battery cleaner for awhile now. The Z1's call for a headlamp of 12V 50/35 Watt and I put in a 12V, 60/40Watt lamp. Would this give me a problem?

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum