kz1000p engine noise

  • officer bubbles
  • officer bubbles's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 7
  • Thanks: 1

kz1000p engine noise

08 Jun 2011 21:12
#456206
This past sunday I went and fired my bike after sitting for bout two months. It first started on 1 cylender then stalled. I then retried to start it and it fired on 3 cylenders. When it fired it was make a loud nose almost sounded like a rod knock. I shot the bike off wright away. Let it sit for a few mins then restarted and its still running on 3 cylenders but the noise got alot quieter. It still respondes very well but its running on 3 cylenders. I know this cause I touched the headers and cylender 3 is warm bout not hot like the others. Where should I start to help narrow down the problem?

Thank you very much for all your help

Please Log in or Create an account to join the conversation.

  • bigkzfan
  • bigkzfan's Avatar
  • Offline
  • User
  • User
    Registered
  • if grandpa had tits he"d be grandma, if
  • Posts: 156
  • Thanks: 1

Re: kz1000p engine noise

08 Jun 2011 21:34
#456210
sounds like fuel delivery issue if compression is good
hello, i own a 1982 kz1000 j model with a 4into1 header and factory air box...

Please Log in or Create an account to join the conversation.

  • TeK9iNe
  • TeK9iNe's Avatar
  • Offline
  • User
  • User
    Registered
  • What did you do!?!
  • Posts: 2436
  • Thanks: 28

Re: kz1000p engine noise

08 Jun 2011 22:28
#456219
Can you get it hot enough to close the choke completely?
If so, does the last pipe get hot if you increase the idle?

If so, may be seriously out of sync. (not likely unless linkage was disturbed).
If not, then the pilot circuit can be clogged with some kind of debris. Or the float bowl is not filling completely because of a stuck float. Or there could be an air leak developing... etc.

Try rapping the carbs sharply on the side with the side of your fist to see if that helps.

Noise can be cam chain slack that is being pulled uneven with a cylinder not firing.

B)
Motorcycle Shop Owner/Operator

79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors ;)

Please Log in or Create an account to join the conversation.

  • officer bubbles
  • officer bubbles's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 7
  • Thanks: 1

Re: kz1000p engine noise

08 Jun 2011 22:34
#456220
I can run the bike with no choke. if i let it idle the pipe stays cool then if I keep the rpms up a little then the pipe warms up a little.

Please Log in or Create an account to join the conversation.

  • otakar
  • otakar's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 5069
  • Thanks: 29

Re: kz1000p engine noise

08 Jun 2011 22:35
#456221
If you heard a knocking sound you may have had a stuck valve and the piston kissed it. I would check the compression on the cold cylinder.
74 Z1-A stock
76 KZ-900 Totaly stock vice MAC pipe
77 KZ-1000A stock
78 Z1-R 100%MINT 500 original Mi.
78 Z1-R Yoshi 1103 kit stage 1 cams Yoshi pipe. Etc
79 KZ-1300 (1400)
80 KZ-1300
81 Scratch built GPz1150R
82 KZ1000

Please Log in or Create an account to join the conversation.

  • officer bubbles
  • officer bubbles's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 7
  • Thanks: 1

Re: kz1000p engine noise

08 Jun 2011 22:38
#456224
Would you happen to know what my compression should be at? Thanks

Please Log in or Create an account to join the conversation.

  • otakar
  • otakar's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 5069
  • Thanks: 29

Re: kz1000p engine noise

08 Jun 2011 22:41
#456226
Don't worry about the compression #s themselvs. I would just make sure that all four cylinders are within 10-12PSI of each other.
74 Z1-A stock
76 KZ-900 Totaly stock vice MAC pipe
77 KZ-1000A stock
78 Z1-R 100%MINT 500 original Mi.
78 Z1-R Yoshi 1103 kit stage 1 cams Yoshi pipe. Etc
79 KZ-1300 (1400)
80 KZ-1300
81 Scratch built GPz1150R
82 KZ1000
The following user(s) said Thank You: officer bubbles

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum