Oil level sight glass
- The Milkman
-
Topic Author
- Offline
- User
-

Registered
- Posts: 794
- Thanks: 194
Oil level sight glass
13 Jun 2011 22:58
I figured whle I have the bottom of the engine apart I would clean the sight glass so I could actually see how much oil I have. I've tried cleaning it but nothing is getting it clean.
when I put the new one in does it go in dry or with a sealer. The original looked like there wasn't anything on it.
Thanks,
Les
when I put the new one in does it go in dry or with a sealer. The original looked like there wasn't anything on it.
Thanks,
Les
78 650-C2, Stock engine, Jardine 4-2 Exh., 17-38 sprockets, dyna ignition and coils, coil wiring mod, carb mod.
Please Log in or Create an account to join the conversation.
- Jeff.Saunders
-
- Offline
- Vendor
-

Vendors
- Posts: 1238
- Thanks: 149
Re: Oil level sight glass
13 Jun 2011 23:02
Dry... they are just a press fit - the rubber seal holds them in place. There's no internal pressure pushing them out.
Please Log in or Create an account to join the conversation.
- The Milkman
-
Topic Author
- Offline
- User
-

Registered
- Posts: 794
- Thanks: 194
Re: Oil level sight glass
13 Jun 2011 23:06
Thank you Jeff, I'll see you in a couple weeks after I get this thing buttoned up and running again. Hopefully, it'll make the trip from Maine again...

Les
Les
78 650-C2, Stock engine, Jardine 4-2 Exh., 17-38 sprockets, dyna ignition and coils, coil wiring mod, carb mod.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
