One Glowing header...
- Thecreeper77
-
Topic Author
- Offline
- User
-

Registered
- Posts: 26
- Thanks: 0
One Glowing header...
15 Jun 2011 15:00
So I Started my KZ up today and let it warm up a bit. It was idling at about 2-3K (known carb issues)and i noticed header #3 was glowing. I idled down and it stopped. Rode it around for less than 10 min and didn’t notice it again. What could be the issue here? I suspect that carb #3 is a bit lean?
Any advice or assistance would be appreciated.
Any advice or assistance would be appreciated.
1980 KZ1000
2008 Versys
2008 Versys
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: One Glowing header...
15 Jun 2011 17:04
Probably running very lean on that cylinder.
1979 KZ-750 Twin
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: One Glowing header...
15 Jun 2011 18:25
Pull the sparkplug for that cylinder. If the center insulator is white, you're running far too lean and could melt the piston or damage the valves.
Check the ducting(boots) from the air filter box to the carb and between the carb and engine(carb holders) for signs of a vacuum leak. To determine where it might be, use a spray of WD-40,carb cleaner or an UNLIT propane torch on the rubber bits while the engine idles.
If the rpm goes up, you've found the leak. Also check the rubber sync ports for cracking as this could also be a source for leaks.
Check the ducting(boots) from the air filter box to the carb and between the carb and engine(carb holders) for signs of a vacuum leak. To determine where it might be, use a spray of WD-40,carb cleaner or an UNLIT propane torch on the rubber bits while the engine idles.
If the rpm goes up, you've found the leak. Also check the rubber sync ports for cracking as this could also be a source for leaks.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- H1Vindicator
-
- Offline
- User
-

Registered
- Posts: 909
- Thanks: 168
Last edit: 22 Jan 2013 00:58 by H1Vindicator.
Please Log in or Create an account to join the conversation.
- Thecreeper77
-
Topic Author
- Offline
- User
-

Registered
- Posts: 26
- Thanks: 0
Re: One Glowing header...
15 Jun 2011 21:13
Well, I’m gona take it to a shop to see if they can evaluate the motor for me. See what’s up and what other issues they can find. If there is damage to the motor(cylinder or valves) due to the lean mixture, is that fixable? If not, anyone need parts?
1980 KZ1000
2008 Versys
2008 Versys
Please Log in or Create an account to join the conversation.
- DoubleDub
-
- User
-

Public
- Thanks: 0
Re: One Glowing header...
15 Jun 2011 21:30 - 15 Jun 2011 21:31
It's more likely a carb issue causing the lean condition...or intake manifold leak causing extra air to be allowed into the chamber.
Last edit: 15 Jun 2011 21:31 by DoubleDub.
Please Log in or Create an account to join the conversation.
- KZ_Rage
-
- Offline
- User
-

Registered
- Kentucky Bourbon Barrel Ale
- Posts: 891
- Thanks: 19
Re: One Glowing header...
15 Jun 2011 22:08 - 15 Jun 2011 22:09
Glowing? Never got one that hot but the evidence points to extremely lean. Does it always want to idle that high to stay running?
There is only one shop around here that might work on something as old as our bikes but the cost is crazy. I do all my own work and when I get too old to do that then I guess the bikes get sold.
Your bike is very fixable, don't get discouraged, just take a look at what mine looked like before I brought her back to life (that's gas and Indiana red clay, it ran but was spitting gas the whole 1/4 mile I rode it to be sure the trans was good).
There is only one shop around here that might work on something as old as our bikes but the cost is crazy. I do all my own work and when I get too old to do that then I guess the bikes get sold.
Your bike is very fixable, don't get discouraged, just take a look at what mine looked like before I brought her back to life (that's gas and Indiana red clay, it ran but was spitting gas the whole 1/4 mile I rode it to be sure the trans was good).
1979 KZ1000E1 SOLD!
1984 KZ550F2 SOLD!
2006 ZG1000A6F (Totaled)
2001 ZRX1200R (Sold)
2001 Sprint 955i ST (daily rider)
1984 KZ550F2 SOLD!
2006 ZG1000A6F (Totaled)
2001 ZRX1200R (Sold)
2001 Sprint 955i ST (daily rider)
Last edit: 15 Jun 2011 22:09 by KZ_Rage.
Please Log in or Create an account to join the conversation.
- martin_csr
-
- Offline
- User
-

Registered
- Posts: 7993
- Thanks: 1648
Last edit: 14 Feb 2013 11:23 by martin_csr.
Please Log in or Create an account to join the conversation.
- otakar
-
- Offline
- User
-

Registered
- Posts: 5069
- Thanks: 29
Re: One Glowing header...
16 Jun 2011 23:04
Talking about glowing headers. Watch this video.
74 Z1-A stock
76 KZ-900 Totaly stock vice MAC pipe
77 KZ-1000A stock
78 Z1-R 100%MINT 500 original Mi.
78 Z1-R Yoshi 1103 kit stage 1 cams Yoshi pipe. Etc
79 KZ-1300 (1400)
80 KZ-1300
81 Scratch built GPz1150R
82 KZ1000
76 KZ-900 Totaly stock vice MAC pipe
77 KZ-1000A stock
78 Z1-R 100%MINT 500 original Mi.
78 Z1-R Yoshi 1103 kit stage 1 cams Yoshi pipe. Etc
79 KZ-1300 (1400)
80 KZ-1300
81 Scratch built GPz1150R
82 KZ1000
Please Log in or Create an account to join the conversation.
- DoubleDub
-
- User
-

Public
- Thanks: 0
Please Log in or Create an account to join the conversation.
- mtbspeedfreak
-
- Offline
- User
-

Registered
- Posts: 1413
- Thanks: 36
Re: One Glowing header...
17 Jun 2011 03:21 - 17 Jun 2011 13:34
What a 'tard. I hope he throws a rod.
To clarify, I meant the guy in the video. I read through this thread this morning and many apologies if thecreeper77 took offense. :blink:
To clarify, I meant the guy in the video. I read through this thread this morning and many apologies if thecreeper77 took offense. :blink:
2000 ZRX 1100
1976 KZ 900- Daily Driver
1980 LTD 550- Dalton Highway survivor!
If it has tits or tires, it'll give you problems!
1976 KZ 900- Daily Driver
1980 LTD 550- Dalton Highway survivor!
If it has tits or tires, it'll give you problems!
Last edit: 17 Jun 2011 13:34 by mtbspeedfreak.
Please Log in or Create an account to join the conversation.
- KZ250LTD
-
- Offline
- User
-

Registered
- Posts: 1311
- Thanks: 16
Last edit: 13 Feb 2012 18:24 by KZ250LTD.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
