Just started smoking

  • badr0bot
  • badr0bot's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 66
  • Thanks: 0

Just started smoking

01 Jul 2011 23:43
#460577
I pulled my bike out of the garage a few weeks ago and ran her a few times. She was running good for awhile but soon started to exhibit what I thought was a fouled plug. she was running really poorly on at least one cylinder but that cylinder wasn't totally dead. I pulled the plug wires one at a time to figure out which one it was. I pulled that plug today and it was all black so replaced it with a new one and gapped it to .030. She started great and purred on all four for about two minutes then started smoking and stumbling on the road. She didn't smoke at all even when she felt like she was miss-firing before. Then all of a sudden with a new plug she smokes and stumbles even worse but only after running great for a few minutes. What do you think that means?
87 KZ1000 P1

Please Log in or Create an account to join the conversation.

  • TeK9iNe
  • TeK9iNe's Avatar
  • Offline
  • User
  • User
    Registered
  • What did you do!?!
  • Posts: 2436
  • Thanks: 28

Re: Just started smoking

02 Jul 2011 10:33 - 02 Jul 2011 10:34
#460622
Only happening to one cylinder means its not likely ignition.
Could be that float bowl is overflowing. Try giving the carbs a sharp rap with the side of your fist/rubber mallet once this starts happening to see if you can re-seat the float valve. If the problem suddenly goes away, I would think its time for some house keeping in those carbs.

Good luck.

B)
Motorcycle Shop Owner/Operator

79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors ;)
Last edit: 02 Jul 2011 10:34 by TeK9iNe.

Please Log in or Create an account to join the conversation.

  • badr0bot
  • badr0bot's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 66
  • Thanks: 0

Re: Just started smoking

02 Jul 2011 18:26
#460670
I noticed that the petcock was leaking in the PRI position. Took it apart and one of the diaphragms is torn. I'm guessing that hole was leaking vacuum pressure so the valve might not be opening completely. Put in the new gaskets and that took care of the stumbling and the smoking. I'm guessing it was a combination of a fouled plug and the petcock going out at the same time. She was just starved for fuel.
87 KZ1000 P1

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum