shift shaft seal
- Chaotic Reason
-
Topic Author
- Offline
- User
-

Registered
- Posts: 384
- Thanks: 15
shift shaft seal
05 Jul 2011 23:48
So, the best way to replace one on a 80 kz1000 shaft:
Option 1- To take everything apart, housing covers, remove the shaft drive, yada yada yada.
Option 2- Screw a screw into it, (not too far of course), and pull the seal out? Put some tape over the tines of the shift shaft, put some motor oil on the seal and then slide it down the shaft and tap it into place?
Attachment DSCF0861_2011-07-05.JPG not found
Option 1- To take everything apart, housing covers, remove the shaft drive, yada yada yada.
Option 2- Screw a screw into it, (not too far of course), and pull the seal out? Put some tape over the tines of the shift shaft, put some motor oil on the seal and then slide it down the shaft and tap it into place?
Michael
1980 KZ1000 shaft drive
1980 KZ1000 shaft drive
Please Log in or Create an account to join the conversation.
- jonnybravo
-
- Offline
- Banned
-

Registered
- Posts: 518
- Thanks: 18
Re: shift shaft seal
06 Jul 2011 00:21
there was a post on how to do this without taking everthing apart, i think is by gearhead, it can be done, search for it i know its here
The following user(s) said Thank You: Chaotic Reason
Please Log in or Create an account to join the conversation.
- Chaotic Reason
-
Topic Author
- Offline
- User
-

Registered
- Posts: 384
- Thanks: 15
Re: shift shaft seal
06 Jul 2011 04:11
Cheers Jonny. I scoured the forum and found quite a few posts on this subject. And it was a similar story, to do the repair the one way or the other. I think I'll try the easy method first and then if it doesn't work, go for the more in depth one.
Thanks again.
Thanks again.
Michael
1980 KZ1000 shaft drive
1980 KZ1000 shaft drive
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
