cracked head i think.
- my48_gmc
-
Topic Author
- Offline
- User
-

Registered
- Posts: 6
- Thanks: 0
cracked head i think.
12 Jul 2011 16:13
im working an 81 kz550 iv cleand the carbs the intake manifolds are good the vacume lines are hooked up and its got good compretion. but it when i take it off of choke it woke hardley run iv set the idle up and that dont help. it sounds like its sucking air put i dont know where becouse every thing is good. i was wondering if the head is cracked or a vavle is stuck. any ideas?
Please Log in or Create an account to join the conversation.
- 531blackbanshee
-
- Offline
- Vendor
-

Vendors
- Posts: 7442
- Thanks: 796
Re: cracked head i think.
12 Jul 2011 16:58
whats the chance of a birdsnest in the exhaust pipe?
leon
leon
skiatook,oklahoma 1980 z1r,1978 kz 1000 z1r x 3,
1976 kz 900 x 3
i make what i can,and save the rest!
billybiltit.blogspot.com/
www.kzrider.com/forum/5-chassis/325862-triple-tree-custom-work
kzrider.com/forum/5-chassis/294594-frame-bracing?limitstart=0
1976 kz 900 x 3
i make what i can,and save the rest!
billybiltit.blogspot.com/
www.kzrider.com/forum/5-chassis/325862-triple-tree-custom-work
kzrider.com/forum/5-chassis/294594-frame-bracing?limitstart=0
Please Log in or Create an account to join the conversation.
- my48_gmc
-
Topic Author
- Offline
- User
-

Registered
- Posts: 6
- Thanks: 0
Re: cracked head i think.
12 Jul 2011 20:34
well it fires on all 4 its just when i even crack the choke it dies unless i mash the throttle
Please Log in or Create an account to join the conversation.
- GPz550D1
-
- Offline
- User
-

Registered
- Posts: 254
- Thanks: 22
Re: cracked head i think.
12 Jul 2011 20:56 - 12 Jul 2011 20:59
If you suspect a head or valve problem, a compression test may help diagnose that. Consider the possiblility that one or more of your pilot jets are stopped up. Also, pilot air screws should be set at 1-1/4 turns out for initial testing.
1981 KZ550-D1
Last edit: 12 Jul 2011 20:59 by GPz550D1.
Please Log in or Create an account to join the conversation.
- TeK9iNe
-
- Offline
- User
-

Registered
- What did you do!?!
- Posts: 2436
- Thanks: 28
Re: cracked head i think.
12 Jul 2011 21:56
I wouldnt go so far as to think you have a cracked head or bad valve when you say the compression is fine.
Do as has been mentioned - make certain there are no small air leaks.
Adjsut the mixture screws accordingly - make them richer until the bike starts to stumble, then back them off about 1/2 turn or so - to that sweet high idle spot. If the mix screws are all over the place different once you've done this - or they dont respond at all, then you have air leaks or clogged pilot circuits.
Good luck.
Do as has been mentioned - make certain there are no small air leaks.
Adjsut the mixture screws accordingly - make them richer until the bike starts to stumble, then back them off about 1/2 turn or so - to that sweet high idle spot. If the mix screws are all over the place different once you've done this - or they dont respond at all, then you have air leaks or clogged pilot circuits.
Good luck.
Motorcycle Shop Owner/Operator
79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors
79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors
Please Log in or Create an account to join the conversation.
- my48_gmc
-
Topic Author
- Offline
- User
-

Registered
- Posts: 6
- Thanks: 0
Re: cracked head i think.
13 Jul 2011 11:30
well i built a custom tank for it and mm using a petcock off of a honda three wheeler. so i was wondering if it had something to do with that vacume pump. i plugged it were the carb is suppsed to pull off of that put i dont know i i have to have the pump on it or not.
Please Log in or Create an account to join the conversation.
- TeK9iNe
-
- Offline
- User
-

Registered
- What did you do!?!
- Posts: 2436
- Thanks: 28
Re: cracked head i think.
16 Jul 2011 19:48
The carbs dont pull fuel, they are gravity fed. No pump required.
As long as fuel flows freely from the petcock and into the carbs, you should be ok.
The level of the fuel has to be the same in all four carbs, and should be set to spec.
You probly have air leaks. Check with the air/mixture screws, like I said.
Or get the service manual...
As long as fuel flows freely from the petcock and into the carbs, you should be ok.
The level of the fuel has to be the same in all four carbs, and should be set to spec.
You probly have air leaks. Check with the air/mixture screws, like I said.
Or get the service manual...
Motorcycle Shop Owner/Operator
79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors
79 Kawie Z1000 LTD
81 Kawie Z1000 CSR
83 Honda VT750C A
85 Kawie GPZ900 A2
86 Zukie GS1150 EG
93 Yamie XV1100 E
Lucky to have rolled many old bikes through my doors
Please Log in or Create an account to join the conversation.
- uncledirt
-
- Offline
- User
-

Registered
- Posts: 54
- Thanks: 0
Re: cracked head i think.
16 Jul 2011 22:41
Are you positive you don't have a hairline crack in the rubber intakes from the air cleaner to the carbs? I also saw a loose bolt at the clamp on a 4 -1 pipe going into the engine cause serious problems, only way we found out was a stethascope with a long slender aluminum tube piece modified on the end so we could stick it into small places and listen better. Guess I'd need to know more of the picture and sounds.
77 KZ650 'C'
Bachelors know more about women than married men; if they didn't they'd be married too.
Bachelors know more about women than married men; if they didn't they'd be married too.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
