1983 1100 spectre compression question
- garyprather
-
Topic Author
- Offline
- User
-

Registered
- Posts: 133
- Thanks: 0
1983 1100 spectre compression question
13 Aug 2011 16:54
I checked my comression on all cyclinders. the lowest reading I had was 185. This was with throttle open. My question is I checked it while cold and got these readings. I did not check it when it hot. Are these readings good.
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: 1983 1100 spectre compression question
13 Aug 2011 17:33
If possible, list all 4 readings, for best engine performance, they should be within 10% of each other. Did you check the valve clearances? If valves are "Tight" (minimun clearance)as the engine warms up the space(clearance) reduces possible burning the valve/valve seats.
A new/rebuilt engine might have 180-200 PSI, put some years on it and now it might be 165 PSI or so. An engine will run at 100 PSI, but produce low power.
A new/rebuilt engine might have 180-200 PSI, put some years on it and now it might be 165 PSI or so. An engine will run at 100 PSI, but produce low power.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- garyprather
-
Topic Author
- Offline
- User
-

Registered
- Posts: 133
- Thanks: 0
Re: 1983 1100 spectre compression question
13 Aug 2011 18:37 - 13 Aug 2011 18:43
I bought the bike about 2 months ago and all the seller told me was that he just went through the valves. He also said that they were all withing spec. other than one that he did need to add to get it within the tolerance. He said he only checked it because the bike had a slight coughing through the carbs. The adjustments did not take care of the cough though. The bike is jetted for a mac 4 into 1 and pods. It seems to have a slight spit and sputter at lower speeds under 2500rpm. The top of the pistons look good just inspecting though the plug hole, not seeing any carbon build up. I tried to sync my carbs with a single vacuum gauge with no luck. Over all the bike runs really well, pulls hard in every gear. Vary impressive performance. Just wanted to clear up that chug that happens at lower speeds. Which is what made me check the compression. The bike has 17k miles on it. Its hard to believe a bike with that many miles has these numbers.
#1= 188
#2= 182
#3= 180
#4= 190
#1= 188
#2= 182
#3= 180
#4= 190
Last edit: 13 Aug 2011 18:43 by garyprather.
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: 1983 1100 spectre compression question
13 Aug 2011 19:04
Open up a CD sized cover on the right side of the engine, inside you should see the pick up coils for the ignition system and mechanical advancer. These advancers need periodic attention by lubricating the moving parts.To see if it's working, with the engine off, give it a twist, it should return back to original position.
If it's sticking, remove the inner bolt(maybe 13mm) and clean and lube the advancer.I use a light lubrication like 3-in-one or sewing machine oil on my bikes advancer.The weight pivots,spring attachment points, and the sleeve it rotates on need lube.
Make note of how it's assembled as it can be put back together 180 degrees out...
If it's sticking, remove the inner bolt(maybe 13mm) and clean and lube the advancer.I use a light lubrication like 3-in-one or sewing machine oil on my bikes advancer.The weight pivots,spring attachment points, and the sleeve it rotates on need lube.
Make note of how it's assembled as it can be put back together 180 degrees out...
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- garyprather
-
Topic Author
- Offline
- User
-

Registered
- Posts: 133
- Thanks: 0
Re: 1983 1100 spectre compression question
13 Aug 2011 19:20
I have checked it with a timing light and the advance is moving. Now I will have to see if it is returning fully down.
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: 1983 1100 spectre compression question
13 Aug 2011 19:39
What brand of sparkplug being used? If NGK,try either Denso W24-ESU's or Accel #116's gapped between 0.028" to 0.032". I've had more than a few NGK's fail right out of the box.
Sparkplug Cross Index
www.gadgetjq.com/spark_plug_cross_reference_motorcycle.htm
www.slideshare.net/carmenitadinutzaa/fac...ual-instant-download
You might think about replacing the ignition coils, & sparkplug wires. Even when new the coils were marginal, add years,heat & vibration and I think it's time to replace some of the ignition parts.
Accel makes a good 3 ohm coil and Dyna has 2.2 and 3 ohm coils that might work. If in doubt, contact here, "Otakar" or "Loudhvx" about ignition coil choices.
Sparkplug Cross Index
www.gadgetjq.com/spark_plug_cross_reference_motorcycle.htm
www.slideshare.net/carmenitadinutzaa/fac...ual-instant-download
You might think about replacing the ignition coils, & sparkplug wires. Even when new the coils were marginal, add years,heat & vibration and I think it's time to replace some of the ignition parts.
Accel makes a good 3 ohm coil and Dyna has 2.2 and 3 ohm coils that might work. If in doubt, contact here, "Otakar" or "Loudhvx" about ignition coil choices.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: 1983 1100 spectre compression question
13 Aug 2011 19:43
Ignition Coil Primary And Secondary Wiring
Ignition coils on the 80’s Kz1000,Kz1100’s and Gpz1100’s are wired the same, that is as you sit on the bike, the LEFT ignition coil primary(small wires) are two wires, RED and BLACK. The secondary (or sparkplug wires) go to #1 and #4 sparkplugs(your primary wiring may be different).
The cylinders are numbered left to right as you sit on the seat; #1,#2,#3, and #4.
For the RIGHT ignition coil, the primary wires, again are two wires, RED and GREEN, with the secondary going to #2 and #3.
The RED wire gets it’s voltage from the run/stop switch on the right handlebar switch pod. Your primary wiring may have a different color.
The BLACK and GREEN wires connect to the IC Igniter(if the bike has the Kawasaki supplied electronic ignition) it actually gives the coils their grounds to fire the sparkplugs.
Primary(small wires) side of the coils will read between 1.8 to 3.0 ohms.
Secondary(sparkplug wire ports)side of the coil will read between 10.4K to 15.6K ohms. These ports are wired together, so it makes no difference which is used, as long as the correct coil to sparkplug configuration is followed.
The sparkplug caps should read 5K OHMS, any higher, or a reading of infinity means new caps should be ordered.
To stress the ignition coils, take a hair dryer, heat the coils and see if the ohm readings change from cold to hot . If they do, it’s time to buy new coils.
Keep in mind, the wiring is reversed for the 550’s 650‘s and 750‘s, that is the RIGHT coil primary will be two wires, RED and BLACK with the secondary(sparkplugs) going to #1 and #4.
The LEFT coils primary wiring would be again two wires, RED and GREEN, with the secondary(sparkplugs) going to #2 and #3.
These engines have what is known as a “Wasted Spark” that is, a sparkplug will fire during an exhaust stroke. It does no damage and many other motorcycle engines have this design.
Ignition coils on the 80’s Kz1000,Kz1100’s and Gpz1100’s are wired the same, that is as you sit on the bike, the LEFT ignition coil primary(small wires) are two wires, RED and BLACK. The secondary (or sparkplug wires) go to #1 and #4 sparkplugs(your primary wiring may be different).
The cylinders are numbered left to right as you sit on the seat; #1,#2,#3, and #4.
For the RIGHT ignition coil, the primary wires, again are two wires, RED and GREEN, with the secondary going to #2 and #3.
The RED wire gets it’s voltage from the run/stop switch on the right handlebar switch pod. Your primary wiring may have a different color.
The BLACK and GREEN wires connect to the IC Igniter(if the bike has the Kawasaki supplied electronic ignition) it actually gives the coils their grounds to fire the sparkplugs.
Primary(small wires) side of the coils will read between 1.8 to 3.0 ohms.
Secondary(sparkplug wire ports)side of the coil will read between 10.4K to 15.6K ohms. These ports are wired together, so it makes no difference which is used, as long as the correct coil to sparkplug configuration is followed.
The sparkplug caps should read 5K OHMS, any higher, or a reading of infinity means new caps should be ordered.
To stress the ignition coils, take a hair dryer, heat the coils and see if the ohm readings change from cold to hot . If they do, it’s time to buy new coils.
Keep in mind, the wiring is reversed for the 550’s 650‘s and 750‘s, that is the RIGHT coil primary will be two wires, RED and BLACK with the secondary(sparkplugs) going to #1 and #4.
The LEFT coils primary wiring would be again two wires, RED and GREEN, with the secondary(sparkplugs) going to #2 and #3.
These engines have what is known as a “Wasted Spark” that is, a sparkplug will fire during an exhaust stroke. It does no damage and many other motorcycle engines have this design.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- garyprather
-
Topic Author
- Offline
- User
-

Registered
- Posts: 133
- Thanks: 0
Re: 1983 1100 spectre compression question
13 Aug 2011 21:39
I do have nkg B8ES plugs in it right now. The coil wires are yellow superstock supression core wires. The coil in it looks new but then again plastic cleans up well. I will check what you posted. Bye the way I did lub the advancer. it had a slight squick to it when i moved it by hand. Yet to take it for a ride. thank you for the help.
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: 1983 1100 spectre compression question
13 Aug 2011 21:50
Glad I could help, I enjoy keeping these old bikes on the road.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- garyprather
-
Topic Author
- Offline
- User
-

Registered
- Posts: 133
- Thanks: 0
Re: 1983 1100 spectre compression question
13 Aug 2011 22:15
I grew up around these bikes. I was to young to ride but my dad use to spin me around town on the old kz900 and 1000's. My wife let me buy one lol. I love this bike.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
