cams and tolerances
- markosportsbikes
-
Topic Author
- Offline
- User
-

Registered
- Posts: 16
- Thanks: 0
cams and tolerances
17 Aug 2011 20:31
i have acomplete rebuild i have 4x cams i am having problems with gaps for shims is there a formula for the more ratical cams or is the tolerance the same 0.002 0.005 my gaps at this point are 0.010 0.014 every thing is in specs as far as springs valves and retainers please help
Please Log in or Create an account to join the conversation.
- z1kzonly
-
- Offline
- User
-

Registered
- Sustaining Member
- Posts: 2815
- Thanks: 527
Re: cams and tolerances
17 Aug 2011 22:23
I would stick to .004 - .006.
4X sounds like a CWC .420 cam. I have a set of them and they have 4X stamped in them.
I would say they could be ran with shim on top as long as the .006 max is followed.
4X sounds like a CWC .420 cam. I have a set of them and they have 4X stamped in them.
I would say they could be ran with shim on top as long as the .006 max is followed.
Livin in "CheektaVegas, NY
Went thru 25 of these in 40 yrs.
I SOLD OUT! THE KAW BARN IS EMPTY.
More room for The Old Girl, Harley 75 FLH Electra Glide,
Old faithful! Points ign. Bendix Orig. carb.
Starts everytime!
Went thru 25 of these in 40 yrs.
I SOLD OUT! THE KAW BARN IS EMPTY.
More room for The Old Girl, Harley 75 FLH Electra Glide,
Old faithful! Points ign. Bendix Orig. carb.
Starts everytime!
The following user(s) said Thank You: markosportsbikes
Please Log in or Create an account to join the conversation.
- APE Jay
-
- User
-

Public
- Thanks: 0
Re: cams and tolerances
18 Aug 2011 02:35 - 18 Aug 2011 02:36
4X is probably Andrews 4x. .430 lift. Don't run them with shim on top. CWC is the company that makes the billet blank.
Last edit: 18 Aug 2011 02:36 by APE Jay.
Please Log in or Create an account to join the conversation.
- TexasKZ
-
- Offline
- Platinum Member
-

Registered
- Posts: 8420
- Thanks: 2804
Re: cams and tolerances
18 Aug 2011 08:54
Andrews says .004 gap. Like Ape Jay says, as a rule, any cam with more than .410 lift should use shim under bucket and piston clearance should be checked.
www.andrewsproducts.com/PDF_files/KZ900-1.pdf
www.andrewsproducts.com/PDF_files/KZ900-1.pdf
1982 KZ1000 LTD parts donor
1981 KZ1000 LTD slowly moving toward resurrection
2000 ZRX1100 not ridden enough
www.kzrider.com/forum/11-projects/620336...amateur-build-thread
1981 KZ1000 LTD slowly moving toward resurrection
2000 ZRX1100 not ridden enough
www.kzrider.com/forum/11-projects/620336...amateur-build-thread
The following user(s) said Thank You: markosportsbikes
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
