Mish-Mosh Bike Woes

  • grubdog
  • grubdog's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 35
  • Thanks: 1

Mish-Mosh Bike Woes

18 Sep 2011 11:51
#477635
Recently, I purchased a KZ that looked awesome on the outside, sounded great, but after only four to five rides (two rides to a local mechanic for a brake job and carb sync), the engine now runs terrible. It sounds bad and vibrates hard, so naturally I want to open the engine up to see what's wrong; but If i go in, I'm going all the way. It reminds me of what it sounds like after a valve has smacked the piston.

This bike I own is a mish-mosh bike...put together from parts here and there, but it is one of the nicest looking bikes I have ever seen; even the engine is nice looking. The frame is a 79, the engine is a 78 bottom with a 76 900 top end; bored out to 1015. The body is an 80 B-4. The guy who built it did a great job on the chassis and paint, but perhaps he is not so good with engines.

When I first got the bike, the carbs were dirty...so gas got into the oil. The brakes were chromed, but were not "cleaned up" before assembly, so the pads rubbed the rotors until they were sizzling. Now the engine sounds like it has thrown a valve or something. I don't know where to go from here. Should I keep the bike and rebuild, buy an engine already built, or sell the bike as is and eat my loss. I am a fair mechanic, who can do a good job if I am slow and careful. I also would not mind having a second engine (or bike) around for back-up.

In addition, I have found an untouched, running 78 KZ 1000 for sale locally for 2000 dollars, and I thought that I could put my current bike on the shelf, while riding the other bike until winter begins. When winter begins, open up the engine on the "mish-mosh bike" and get it ready for spring. When the "mish-mosh" bike is running" I will use it for a daily driver, and begin restoration on the 78; and take my time with it.

Scenario 2: Buy a used running engine (Redline has them), put it in my bike, rebuild the bad engine over the winter. Or, I could find an already rebuilt engine, but I have not found any yet.

This is not a sob story, but I have waited 15 LONG YEARS to be back in the saddle, I finally get a bike again and this happens; just as fall is starting. Any ideas?

Please Log in or Create an account to join the conversation.

  • Nebr_Rex
  • Nebr_Rex's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1889
  • Thanks: 295

Re: Mish-Mosh Bike Woes

18 Sep 2011 12:01
#477638
Ran good before sync,now bad....?
2002 ZRX1200R
81 GPz1100
79 KZ1000st daily ride
79 KZ1000mk2 prodject
78 KZ650sr
78 KZ650b
81 KZ750e
80 KZ750ltd
77 KZ400/440 cafe project
76 KZ400/440 Fuel Injected

www.dotheton.com/index.php?threads/dr-je...air-of-kz400s.39120/


.

Please Log in or Create an account to join the conversation.

  • grubdog
  • grubdog's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 35
  • Thanks: 1

Re: Mish-Mosh Bike Woes

18 Sep 2011 12:04
#477639
It ran good after the sync. A couple of rides later it did not. I didn't mention that the engine is noisy too. I hope that it is only the carbs, but it sounds really bad.

Please Log in or Create an account to join the conversation.

  • Nebr_Rex
  • Nebr_Rex's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1889
  • Thanks: 295

Re: Mish-Mosh Bike Woes

18 Sep 2011 12:21
#477641
Two bikes would be better than one. B)


.
2002 ZRX1200R
81 GPz1100
79 KZ1000st daily ride
79 KZ1000mk2 prodject
78 KZ650sr
78 KZ650b
81 KZ750e
80 KZ750ltd
77 KZ400/440 cafe project
76 KZ400/440 Fuel Injected

www.dotheton.com/index.php?threads/dr-je...air-of-kz400s.39120/


.

Please Log in or Create an account to join the conversation.

  • grubdog
  • grubdog's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 35
  • Thanks: 1

Re: Mish-Mosh Bike Woes

18 Sep 2011 12:24
#477642
That is kind of what I was thinking. Plenty of parts. The parts for these old bikes are getting pricey.

Please Log in or Create an account to join the conversation.

  • steell
  • steell's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6849
  • Thanks: 208

Re: Mish-Mosh Bike Woes

18 Sep 2011 14:37
#477655
First thing you should do is a compression test, dry then wet.
KD9JUR

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: Mish-Mosh Bike Woes

18 Sep 2011 16:33 - 18 Sep 2011 20:32
#477677
grubdog wrote: It ran good after the sync. A couple of rides later it did not. I didn't mention that the engine is noisy too. I hope that it is only the carbs, but it sounds really bad.

Was an aftermarket in-line fuel filter installed before any gasoline was allowed into the freshly synced carbs?

A proper carb sync often helps quieten a noisy cam chain.

Would also assure valve clearances are within specs.

And that a fat blue spark is visible on removed plugs held grounded against the engine.

Btw, looks like Z1 carbs (two-screw cap covers) from 1973 Z1 or 1974 Z1 or 1975 Z1. The 1976 KZ900 introduced three-screw cap covers (continued through several later years on the manual slide carbs).

Given decent compression, valve clearances within specs, fresh plugs with good properly timed spark, and cam chain adjusted per FSM, would next address possible carb issues (internal cleanliness and settings) and fuel supply issues.

Good Fortune! :)
1973 Z1
KZ900 LTD
Last edit: 18 Sep 2011 20:32 by Patton.

Please Log in or Create an account to join the conversation.

  • Tyler
  • Tyler's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 845
  • Thanks: 92

Re: Mish-Mosh Bike Woes

18 Sep 2011 16:36 - 18 Sep 2011 16:38
#477679
Before you crank that engine over for a compression test pull the plugs and look down the cylinders with a light. If you did drop a valve or break a piston it will be obvious, also before you crank that engine over make sure the cam chainand tensioner are alright and in proper time.

Then go from there...
If I knew what I was doing all the time life wouldn't be any fun.

'80 KZ650 E 700cc, dyna ignition and coils, frame up restoration, daily driver
'81 KZ1300 A3 full restoration, custom big bore pistons, 1400cc 6 cylinder super bike
"77 KZ650 B1 - Barn Find, work in progeress
"74 Yamaha DT 400 Enduro
Last edit: 18 Sep 2011 16:38 by Tyler.

Please Log in or Create an account to join the conversation.

  • grubdog
  • grubdog's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 35
  • Thanks: 1

Re: Mish-Mosh Bike Woes

18 Sep 2011 20:29
#477721
I really appreciate the feedback. I will begin checking out the engine this week, and post my findings.

Please Log in or Create an account to join the conversation.

  • grubdog
  • grubdog's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 35
  • Thanks: 1

Re: Mish-Mosh Bike Woes

18 Sep 2011 20:34
#477722
I don't doubt that the carbs are from an earlier year. This bike was basically assembled from parts laying around in someone's shop; or from dumpsters.

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum