Need some opinions... strange problem..

  • Cruez
  • Cruez's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 14
  • Thanks: 0

Need some opinions... strange problem..

27 Sep 2011 20:14
#480038
I'm putting the KZ1000 back together now... I did not take apart the engine. It ran when I pulled it out to coat the framne... now...

I went to start it up again, and had no fire from #3. Got spark, got fuel. Checked the compression and is around 20-30. Does it sound like something is stuck.. or something else.. I just find it strange that it happened after reassemble...

Background on the bike, it had been sitting for a few years prior to me getting it.. I only had it running 15 minutes or so before I took the rest of it apart..

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: Need some opinions... strange problem..

27 Sep 2011 20:41
#480042
When the frame was repainted, did you take a M6 X 1 tap and clean out the many grounding places(where usually the Black with Yellow stripe wires go)? You may have a floating ground problem.

Make sure the Negative(-) battery cable from the terminal is making good electrical contact on the mounting bolt too.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

  • MFolks
  • MFolks's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6650
  • Thanks: 541

Re: Need some opinions... strange problem..

27 Sep 2011 20:47
#480043
Low compression may be due to stuck rings, on engines not run in a while, it may take some runs at almost full throttle to unstick the rings.


Some chemicals that should work to loosen up the stuck rings:

Engine Chemicals
Mopar Combustion Chamber Cleaner # 04318001. Designed to remove carbon from combustion chambers & valves.

Yamaha Combustion Chamber Cleaner ACC110008200
Features: Laboratory and field-tested blend of chemicals to remove power-robbing deposits that accumulate in gasoline engines.

Kleen flo Combustion Chamber Cleaner
STOCK No 823
Purges carbon, gum, varnish, sludge from internal parts. Helps increase gas mileage. Oxygen sensor and catalytic converter safe. Improves engine work. Can be used in exhaust catalyst system.

Yamaha Carb Cleaner # ACC-CARBC-LE-NR

www.amazon.com/Yamaha-Ring-Additive-32oz-ACC-
RNGFR-32-00/dp/B002GUCLH2 (Yamaha Ring Free)

www.barsproducts.com/E10L.htm
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

  • Motor Head
  • Motor Head's Avatar
  • Offline
  • User
  • User
    Registered
  • FIX UP YOUR BIKE RIGHT AND CHEAP
  • Posts: 5137
  • Thanks: 393

Re: Need some opinions... strange problem..

27 Sep 2011 20:53
#480046
I would do a leak down test to see where the compression is going, do all 4 of course.
1982 KZ1000LTD K2 Vance & Hines 4-1 ACCEL COILS Added Vetter fairing & Bags. FOX Racing rear Shocks, Braced Swing-arm, Fork Brace, Progressive Fork Springs RT Gold Emulators, APE Valve Springs, 1166 Big Bore kit, RS34's, GPZ cams.
1980 KZ550LTD C1 Stock SOLD Miss it
1979 MAZDA RX7 in the works, 13B 6 port built/ light flywheel/ 48 DCO Weber LUV IT! Street Legal Go Cart!
1982 KZ1100 A-2 Shaft just bought it in pieces form 1st owner: Now Running Great! SOLD
1990 Concours 1000 Project bike rough body work: Now Running & Riding!
www.kz1000r.com/downloads/Kawasaki%20KZ1...Service%20Manual.pdf

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: Need some opinions... strange problem..

28 Sep 2011 06:01
#480153
Cruez wrote: ...no fire from #3. Got spark, got fuel. Checked the compression and is around 20-30....

One possible cause could be too tight valve clearance in #3.

Good Fortune! :)
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

  • Cruez
  • Cruez's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 14
  • Thanks: 0

Re: Need some opinions... strange problem..

28 Sep 2011 11:47
#480199
Thanks for the quick replies...
Motor Head wrote: I would do a leak down test to see where the compression is going, do all 4 of course.

That was my next test.... borescope after that if I can't determine the cause.

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum