engine sprocket collar
- crackfox1
-
Topic Author
- Offline
- User
-

Registered
- Posts: 27
- Thanks: 0
engine sprocket collar
31 Oct 2011 21:22
Hello all, I recently exchanged my shaft for a chain on my z1000st and have my last thing to sort out, the engine sprocket. I've just discovered there's supposed to be a collar with an O-ring between the crankcase and sprocket inner casing - (trans door if your american) My question may sound daft but, does the sprocket spacer, ie. collar extend beyond the trans door oil seal or does the shoulder on the sprocket sit within the seal ? I've tried to match it up with a spacer today but am struggling with the distance between the seal being nearly 40mm. Any advise would be helpfull. Thank you. simon.
Please Log in or Create an account to join the conversation.
- Rainman
-
- Offline
- User
-

Registered
- and a little Kaw shall lead them
- Posts: 597
- Thanks: 76
Re: engine sprocket collar
31 Oct 2011 22:18 - 31 Oct 2011 22:37
crackfox1, I replaced the transmission output shaft O-ring seal on my wifes 440 twin this summer and the collar went thru the seal for the outside diameter of the collar and up against the bearing. O=ring seals between output shaft and ID of collar, OD of collar is sealed by the case seal.
Checked a 650 engine I have setting around, about 3/4 of the collar length is inside the case seal.
Good luck.
Jim
Checked a 650 engine I have setting around, about 3/4 of the collar length is inside the case seal.
Good luck.
Jim
80 KZ750 H1 - the Kaw calf
79 KZ750 Twin - Miss Nov 2008 KZR calander
79 KZ750 Twin parts bike
78 KZ650 C2 Parts Bike
75 KZ400 Wife's old bike sold
81 KZ440 A2 LTD Wife's new bike
84 Honda 450 Rebel Wife's newest bike
Jim
Quincy,IL
79 KZ750 Twin - Miss Nov 2008 KZR calander
79 KZ750 Twin parts bike
78 KZ650 C2 Parts Bike
75 KZ400 Wife's old bike sold
81 KZ440 A2 LTD Wife's new bike
84 Honda 450 Rebel Wife's newest bike
Jim
Quincy,IL
Last edit: 31 Oct 2011 22:37 by Rainman.
Please Log in or Create an account to join the conversation.
- crackfox1
-
Topic Author
- Offline
- User
-

Registered
- Posts: 27
- Thanks: 0
Re: engine sprocket collar
01 Nov 2011 06:37
Thank's for that jim, I had thought the sprocket shoulder sat within the casing seal. No wonder I was leaking a bit of oil without the collar/spacer and o-ring. simon.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
