wrong transmission cover ?
- crackfox1
-
Topic Author
- Offline
- User
-

Registered
- Posts: 27
- Thanks: 0
wrong transmission cover ?
01 Nov 2011 17:01
Hello, I'm concerned I've bought the wrong inner sprocket cover for my 79 z1000st (being converted to chain drive) The sprocket seal is 40mm ID while the sprocket collar's / spacer's I've been looking to purchase don't look nearly big enough to fill this gap. Also, when I tighten the cover down with a single gasket the pawl's seem to be rubbing on inner side stopping it from going into first. Could it be I've got a trans cover from a j-model instead of a mk2 ? I can make additional gaskets which seems to stop the pawl's catching but I've still the problem with the large oil seal. Any ideas ? Thank you. simon.
Please Log in or Create an account to join the conversation.
- Jack
-
- Offline
- User
-

Registered
- Posts: 691
- Thanks: 7
Re: wrong transmission cover ?
01 Nov 2011 17:38
First thing I'd check is whether or not the MKll and ST share the exact same countersprocket cover. The MKll and J model covers ( 'mission cover in Kawispeak) are same size/shape, not sure of output shaft diameter and seal.
79 KZ 1075 MKll
79 KZ 1500 MKll dragbike
Gone but not forgotten:
3 X 73 Z1's
1 X 74 Z1A
1 X 75 Z1B
79 KZ 1500 MKll dragbike
Gone but not forgotten:
3 X 73 Z1's
1 X 74 Z1A
1 X 75 Z1B
Please Log in or Create an account to join the conversation.
- etbike3135
-
- Offline
- User
-

Registered
- Posts: 379
- Thanks: 50
Re: wrong transmission cover ?
01 Nov 2011 17:42
Here is a pic of a J and MKII cover. The seal is different but interchangeable, so if you have the 32mm seal it will fit right in your cover. You need EVERYTHING from the chain drive. Shiftdrum, all the stuff on the outside. You should not be using anything except the shift forks from your shaft.
1973 Kawasaki Z1
18 years in dragbikes
18 years in dragbikes
Please Log in or Create an account to join the conversation.
- crackfox1
-
Topic Author
- Offline
- User
-

Registered
- Posts: 27
- Thanks: 0
Re: wrong transmission cover ?
01 Nov 2011 19:16
Thank's for that info. I was hoping I could just change the seal and not replace the cover. either that or make a top hat style sprocket spacer. simon.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
