KZ 650 missing at idle

  • Veazey
  • Veazey's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 21
  • Thanks: 0

KZ 650 missing at idle

11 Dec 2011 09:43
#492633
1979 KZ 650 has a miss, or backfiring through number 4 at idle. Runs fine once you crack open the throttle open. I just purchesed a few months ago and took the carbs off and cleaned them in a solvent tank. I am not an experienced professional but a hobbyist. Can someone provide direction for this issue?

Please Log in or Create an account to join the conversation.

  • KZ250LTD
  • KZ250LTD's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1311
  • Thanks: 16

Re: .

11 Dec 2011 10:31 - 13 Feb 2012 17:40
#492635
.
79 KZ1000ST
Past:
Many.
Last edit: 13 Feb 2012 17:40 by KZ250LTD.

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: KZ 650 missing at idle

11 Dec 2011 10:41
#492636
Veazey wrote: 1979 KZ 650 has a miss, or backfiring through number 4 at idle. Runs fine once you crack open the throttle open. I just purchesed a few months ago and took the carbs off and cleaned them in a solvent tank. I am not an experienced professional but a hobbyist. Can someone provide direction for this issue?

The timing advancer might be sticking, and not properly returning to its correct idle position with F mark alignment.

Would assure correct functioning of the timing advancer.
Using a strobe-type timing light, watch the advancer move quickly back and forth as rpm is varied by blipping the throttle.

Here's an example of an advancer that needs some tlc:



Would also assure correct valve clearances.

Good Fortune! :)
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

  • monkfishing
  • monkfishing's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 6
  • Thanks: 0

Re: KZ 650 missing at idle

11 Dec 2011 12:05
#492646
check in intake rubbers. they are cheap replace them even if they look ok . also after you soaked the carbs. did you clean out all the passageways ? they clog easily. should blow out everything with compressed air. also not sure if your carbs have the little valves in the needles. if so make sure they move freeley. good luck

Please Log in or Create an account to join the conversation.

  • Veazey
  • Veazey's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 21
  • Thanks: 0

Re: KZ 650 missing at idle

12 Dec 2011 07:40
#492759
I checked points and reset gap and timing at the points dynamic timing I think its called. I did not check any restisances on coils or condenser. I will head in that direction next. Also did not blow carbs with compressed air only solvent. I'll take the rack back off and do it again. Thankyou all!

Please Log in or Create an account to join the conversation.

  • KZ250LTD
  • KZ250LTD's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1311
  • Thanks: 16

Re: .

12 Dec 2011 07:56 - 13 Feb 2012 17:39
#492761
.
79 KZ1000ST
Past:
Many.
Last edit: 13 Feb 2012 17:39 by KZ250LTD.
The following user(s) said Thank You: Veazey

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: KZ 650 missing at idle

12 Dec 2011 11:35
#492788
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum