Clutch Release Mechanism

  • grumpy56
  • grumpy56's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 310
  • Thanks: 6

Clutch Release Mechanism

15 Dec 2011 01:05
#493219
Continuing sage with my clutch release mechanism. The 1982 J model switched to a ball-cam type from the ball-screw type used on the 1981 J1. I believe all the later Police models use this same gizmo. About 6 months ago, the cam was slipping on me so I repaced all the components (release, bearing, and cam release). When I compared my old parts to the new ones, I culd not determine what was screwed up with the old parts. Replaced everything and it has been fine, until today. Rolling into my garage this afternoon and DANG, clutch lever to the grip. Took it apart and again did not notice anything that looked bad (I obviously don't know what I'm looking for I guess. I think the release is over-riding the bearings and not returing to the "engaged position". So I applied a bit more "slop" to my clutch thinking that perhaps I was moving that release too far. Worked for a few pulls then DANG, to the grip again. Gave it a bit more slack, and I pulled that thing 100 times and it is still OK. But, there must still be something wrong. Any ideas? Could the liner in the case be worn? Should I later the adjustment from "counterclockwise until bottoming and then 1/4 turn clockwise" (opposite of the 1981 I eventually found out)? Maybe some of you Police guys have run into this. Help appreciated.
Lewis
1982 KZ1000-J2
2006 HD FXD35
1970 Suzuki T350
1972 Suzuki GT380 (In-Process)
In The Past...71 TM400, 72 H-D SS350, 72 GT380, 75 Z1B, 77 XLH, 79 CB750K

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum