Oil leaking from exhaust
- Capt806dfd
-
Topic Author
- Offline
- User
-

Registered
- Posts: 17
- Thanks: 0
Oil leaking from exhaust
07 Jan 2012 13:16
I have had new gaskets and seals installed in the motor for my 1980 650, I have had the carbs rebuilt and this thing will purr like a kitten at idle but if you get it out on the road under a load it starts to blow oil out of the #1 and #4 exhaust when it heats up then craps out until it cools back off. I am not sure where to go from here. Ive had the valves reseated and the shims checked to make sure they are at the right clearences. I have been told it could be the pistons, the rings,possibly a cracked head. Any help would be apprecieated
Please Log in or Create an account to join the conversation.
- 650ed
-
- Offline
- User
-

Registered
- Posts: 15334
- Thanks: 2832
Re: Oil leaking from exhaust
07 Jan 2012 13:31
How can you tell the oil is coming from #1 and #4; is it leaking where the pipes join the head? Ed
1977 KZ650-C1 Original Owner - Stock (with additional invisible FIAMM horn)
Please Log in or Create an account to join the conversation.
- Capt806dfd
-
Topic Author
- Offline
- User
-

Registered
- Posts: 17
- Thanks: 0
Re: Oil leaking from exhaust
07 Jan 2012 18:36
Ed, Yes it is blowing out around the pipes at the head on #1 and #4.
Please Log in or Create an account to join the conversation.
- Fritula
-
- Offline
- User
-

Registered
- holly land garage
- Posts: 46
- Thanks: 0
Re: Oil leaking from exhaust
12 Jan 2012 12:00
hmmm.Not a good thing. The oil could come from head or bottom engine.But you have rebuild your top end.With that in mind it should not happend leaking from head.What was situation before you did your work at top end.Did it smoke or leak maybe?
Please Log in or Create an account to join the conversation.
- Fritula
-
- Offline
- User
-

Registered
- holly land garage
- Posts: 46
- Thanks: 0
Re: Oil leaking from exhaust
12 Jan 2012 12:11
If you by any chance damaged valve seals while installing tham,It would just smoke out the pipes ,since that is just small amount of oil going down the valve stem. When you said that you replaced gaskets and seals,did you mean a whole engine? If you did,could it be your pistons rings misplaced ?Meaning that blowby from a crank pass wrigh up the piston??
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
