76 KZ750 No Spark
- Ryan76KZ750
-
Topic Author
- Offline
- User
-

Registered
- Posts: 4
- Thanks: 0
76 KZ750 No Spark
20 Jan 2012 23:10
I have a 1976 KZ750B Twin that has nooooo spark!!! I have replaced, the coil, points, relays, stator/generator, starter and condensor. I have also replaced the voltage regulator, left hand control and battery. Still no spark.
The bike ran up until last year when I pulled it from storage. (Sidebar - Prior to unloading the bike it tipped over in the pick up and broke a tail light. A little JB weld made that better.)
I have read in other posts that any one of the connections can kill a spark. My question is, Has anyone else experienced this problem and where would be a good place to start? I think I'm looking at a nightmare of wiring any helpful hints are greatly appreciated.
Thanks
Ryan
The bike ran up until last year when I pulled it from storage. (Sidebar - Prior to unloading the bike it tipped over in the pick up and broke a tail light. A little JB weld made that better.)
I have read in other posts that any one of the connections can kill a spark. My question is, Has anyone else experienced this problem and where would be a good place to start? I think I'm looking at a nightmare of wiring any helpful hints are greatly appreciated.
Thanks
Ryan
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: 76 KZ750 No Spark
21 Jan 2012 02:09
Check the blue wire at the coil: it is supposed to go to the points. Unhook the battery, then unhook the blue wire at the coil. Use an Ohm meter to check the blue wire to ground as you turn the engine over (use the kickstarter). The meter should read short to ground when the points are closed and infinite reading when they are open. If you read a short all the time, the points are shorted to ground.
If points check out ok: reconnect the battery and turn on the key. Use voltmeter to measure from the yellow-red coil wire to ground. With key on, you should get at least 10V. If good, the coil should be firing.
You say you installed a new coil? Which one?
If points check out ok: reconnect the battery and turn on the key. Use voltmeter to measure from the yellow-red coil wire to ground. With key on, you should get at least 10V. If good, the coil should be firing.
You say you installed a new coil? Which one?
1979 KZ-750 Twin
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: 76 KZ750 No Spark
21 Jan 2012 08:31Ryan76KZ750 wrote: I have a 1976 KZ750B Twin that has nooooo spark!!! I have replaced, the coil, points, relays, stator/generator, starter and condensor. I have also replaced the voltage regulator, left hand control and battery. Still no spark.
The bike ran up until last year when I pulled it from storage. (Sidebar - Prior to unloading the bike it tipped over in the pick up and broke a tail light. A little JB weld made that better.)
I have read in other posts that any one of the connections can kill a spark. My question is, Has anyone else experienced this problem and where would be a good place to start? I think I'm looking at a nightmare of wiring any helpful hints are greatly appreciated.
Thanks
Ryan
where would be a good place to start?
With ignition switch ON, use voltmeter to measure voltage being received by the coil from the battery.
What voltage is being received by the coil when the ignition switch is ON?
Good Fortune!
1973 Z1
KZ900 LTD
KZ900 LTD
Please Log in or Create an account to join the conversation.
- Ryan76KZ750
-
Topic Author
- Offline
- User
-

Registered
- Posts: 4
- Thanks: 0
Re: 76 KZ750 No Spark
21 Jan 2012 16:30
I will check the volts to the points. I have tried a couple coils. I had a few used ones sitting around, which all test good, none of them produce spark. I did buy a cheapo $60 coil because I do not want to invest $200-$400 if the bike is no good. I can't remember the brand off the top of my head, found it on ebay. It was a universal coil.
I do not get any spark at the points at all. I just replaced the points as well as the condensor. What I'm thinking is when the bike tipped over in the truck prior to unloading it may have caused a short somewhere in the bike.
When the key is on and I turn on the left turn signal it blinks just fine, but when I turn on the right turn signal it just lights up but does not blink. I know the bike uses the frame to ground the turn signals. Do you think the fact that I used JB Weld, to fix the pop metal casting, could be causing the short? Most of the casting is still in tact although liberally coated with JB Weld.
(Prior history, when the points went out and I replaced them. The bike was running although I needed to fine tune the timing. It wasn't until the bike tipped over that it stopped firing. Can a turn signal short out the whole system?)
I do not get any spark at the points at all. I just replaced the points as well as the condensor. What I'm thinking is when the bike tipped over in the truck prior to unloading it may have caused a short somewhere in the bike.
When the key is on and I turn on the left turn signal it blinks just fine, but when I turn on the right turn signal it just lights up but does not blink. I know the bike uses the frame to ground the turn signals. Do you think the fact that I used JB Weld, to fix the pop metal casting, could be causing the short? Most of the casting is still in tact although liberally coated with JB Weld.
(Prior history, when the points went out and I replaced them. The bike was running although I needed to fine tune the timing. It wasn't until the bike tipped over that it stopped firing. Can a turn signal short out the whole system?)
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: 76 KZ750 No Spark
22 Jan 2012 00:18 - 22 Jan 2012 00:19Would ignore volts to points, and use voltmeter to measure voltage being received by the coil from the battery when the ignition switch is ON.Ryan76KZ750 wrote: I will check the volts to the points....
May disconnect the red-yellow wire at its plug-in connector nearest to the coil.
Then switch the ignition ON. Then measure the voltage at the female half of the connector.
What's the voltage?
Good Fortune!
1973 Z1
KZ900 LTD
KZ900 LTD
Last edit: 22 Jan 2012 00:19 by Patton.
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: 76 KZ750 No Spark
22 Jan 2012 23:54Z1 sells the OEM equivalent four Ohm coil for $36. It's the EMGO brand. Forget using old coils.Ryan76KZ750 wrote: I will check the volts to the points. I have tried a couple coils. I had a few used ones sitting around, which all test good, none of them produce spark. I did buy a cheapo $60 coil because I do not want to invest $200-$400 if the bike is no good.
1979 KZ-750 Twin
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: 76 KZ750 No Spark
23 Jan 2012 00:56
Existing coil may be just fine, especially if it passes the ohm tests on primary and secondary loops.
The world's best coil won't function unless it is first receiving adequate voltage to the primary wiring terminal.
where would be a good place to start? -- That's where.
Good Fortune!
The world's best coil won't function unless it is first receiving adequate voltage to the primary wiring terminal.
where would be a good place to start? -- That's where.
Good Fortune!
1973 Z1
KZ900 LTD
KZ900 LTD
Please Log in or Create an account to join the conversation.
- KZJOE900
-
- Offline
- Administrator
-

Super Users
- Posts: 1984
- Thanks: 455
Re: 76 KZ750 No Spark
23 Jan 2012 01:05
Could you haved damaged your kill switch when it fell? Unlikely, but anything is possible.
Current project 76 KZ900 (This was a Vetter model)
76 KZ900
81 XJ550H SECA (Current Project)
82 XJ550R SECA
Past:
86 FJ1200
74 Z1900
72 CB450
76 KZ900
81 XJ550H SECA (Current Project)
82 XJ550R SECA
Past:
86 FJ1200
74 Z1900
72 CB450
Please Log in or Create an account to join the conversation.
- Ryan76KZ750
-
Topic Author
- Offline
- User
-

Registered
- Posts: 4
- Thanks: 0
Re: 76 KZ750 No Spark
26 Jan 2012 18:32
Thank you all for the good info. I will definitely be checking the main harness behind the light. I did give the kill switch a look and everything looked in tact. Part of the problem this time of year is that it's so cold I really can't get a good crank on the bike. This old betty doesn't start if it's below 30 degrees. lol.
I have the bike at a friends' right now so next chance I get I will go investigate and keep you all informed. Thanks again and if any of you have any epiphanies feel free to post those too!!
I have the bike at a friends' right now so next chance I get I will go investigate and keep you all informed. Thanks again and if any of you have any epiphanies feel free to post those too!!
Please Log in or Create an account to join the conversation.
- Ryan76KZ750
-
Topic Author
- Offline
- User
-

Registered
- Posts: 4
- Thanks: 0
Re: 76 KZ750 No Spark
26 Jan 2012 18:34
EMGO was the brand I bought. I just purchased one for $54 (tax & shipping) so I'm positive the coil will function if the required volts are provided. Thanks for the help.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
