ATU Z1000
- limp
-
Topic Author
- Offline
- User
-

Registered
- Posts: 20
- Thanks: 0
ATU Z1000
01 Feb 2012 21:56
Hi all
Can someone help me out here please, i would like to know if on the advance/retard unit there should be a piece of rubber at the end of each arm which makes contact on the main body, on the one i am using has a piece of rubber only on one of the arms. hope this sounds understandable to anyone
Regards
Limp
Can someone help me out here please, i would like to know if on the advance/retard unit there should be a piece of rubber at the end of each arm which makes contact on the main body, on the one i am using has a piece of rubber only on one of the arms. hope this sounds understandable to anyone
Regards
Limp
Hi
I'm Graham (limp)I live in the Leicestershire area of England have just finished this Z1000,it is an H1 engine fitted with carbs which are 29mm mikuni's,LTD frame,Yamaha FJ1100 front end it handles very well and goes like a rocket
I'm Graham (limp)I live in the Leicestershire area of England have just finished this Z1000,it is an H1 engine fitted with carbs which are 29mm mikuni's,LTD frame,Yamaha FJ1100 front end it handles very well and goes like a rocket
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: ATU Z1000
01 Feb 2012 22:24
Supposed to have the rubber pads, but many are missing.
No special action is needed.
Just set timing as usual with F mark aligning with case mark at idle rpm.
Good Fortune!
No special action is needed.
Just set timing as usual with F mark aligning with case mark at idle rpm.
Good Fortune!
1973 Z1
KZ900 LTD
KZ900 LTD
Please Log in or Create an account to join the conversation.
- limp
-
Topic Author
- Offline
- User
-

Registered
- Posts: 20
- Thanks: 0
Re: ATU Z1000
01 Feb 2012 22:41
Thanks for the pic and info i was a little worried this may have caused a problem when going from idle to more revs when pulling away
Kind regards
Limp
Kind regards
Limp
Hi
I'm Graham (limp)I live in the Leicestershire area of England have just finished this Z1000,it is an H1 engine fitted with carbs which are 29mm mikuni's,LTD frame,Yamaha FJ1100 front end it handles very well and goes like a rocket
I'm Graham (limp)I live in the Leicestershire area of England have just finished this Z1000,it is an H1 engine fitted with carbs which are 29mm mikuni's,LTD frame,Yamaha FJ1100 front end it handles very well and goes like a rocket
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
