Most Volatile Mix ???
- blipco
-
Topic Author
- Offline
- User
-

Registered
- 2002 KZ1000P
- Posts: 556
- Thanks: 212
Most Volatile Mix ???
12 Feb 2012 16:51
I bought a 2002 Triumph with a 955 triple that sat for years after being crashed. The rings are either rusted or gummed up. When cranking, I get low compression, less than 60 psi. (I poured Mystery Oil in cylenders over the last couple of months and cranked it). Motor has 10,000 miles, valves are within spec. I need to get it to fire in hopes of shaking up the rings to the point where they might start to do their job again. Is there anything more volatile than poring raw gas into the cylinders to get it to fire? I'm using 87 octane. Otherwise I need to split the cases to re-ring this modern engine. Any ideas?
"Swim against the current, even a dead fish can go with the flow"-somebody (I forget Who)
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: Most Volatile Mix ???
12 Feb 2012 22:46
Some say PB Blaster is good for freeing up rings.
1979 KZ-750 Twin
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: Most Volatile Mix ???
12 Feb 2012 22:47starting fluidblipco wrote: Is there anything more volatile than poring raw gas into the cylinders to get it to fire?
1979 KZ-750 Twin
Please Log in or Create an account to join the conversation.
- Nebr_Rex
-
- Offline
- User
-

Registered
- Posts: 1889
- Thanks: 295
Re: Most Volatile Mix ???
13 Feb 2012 00:03bountyhunter wrote:starting fluidblipco wrote: Is there anything more volatile than poring raw gas into the cylinders to get it to fire?
And a match :evil:
2002 ZRX1200R
81 GPz1100
79 KZ1000st daily ride
79 KZ1000mk2 prodject
78 KZ650sr
78 KZ650b
81 KZ750e
80 KZ750ltd
77 KZ400/440 cafe project
76 KZ400/440 Fuel Injected
www.dotheton.com/index.php?threads/dr-je...air-of-kz400s.39120/
.
81 GPz1100
79 KZ1000st daily ride
79 KZ1000mk2 prodject
78 KZ650sr
78 KZ650b
81 KZ750e
80 KZ750ltd
77 KZ400/440 cafe project
76 KZ400/440 Fuel Injected
www.dotheton.com/index.php?threads/dr-je...air-of-kz400s.39120/
.
Please Log in or Create an account to join the conversation.
- blipco
-
Topic Author
- Offline
- User
-

Registered
- 2002 KZ1000P
- Posts: 556
- Thanks: 212
Re: Most Volatile Mix ???
13 Feb 2012 00:56
So far I've tried PB parts blaster, mystery oil, starting fluid, gas, separately and some or all at once. No luck. Nitro?
"Swim against the current, even a dead fish can go with the flow"-somebody (I forget Who)
Please Log in or Create an account to join the conversation.
- bountyhunter
-
- Offline
- User
-

Registered
- Posts: 7245
- Thanks: 338
Re: Most Volatile Mix ???
13 Feb 2012 05:00
I think if the compression is truly under 60, it isn't enough to fire on. It just doesn't work.
1979 KZ-750 Twin
Please Log in or Create an account to join the conversation.
- testarossa
-
- Offline
- User
-

Registered
- Attack life, it's only trying to kill you.
- Posts: 3673
- Thanks: 83
Re: Most Volatile Mix ???
13 Feb 2012 07:48
Forgive me for asking, but you haven't stated. Have you verified correct ignition function and timing? Also is the battery at full charge? A lot of newer bikes with computer controlled ignitions won't fire if they are cranking too slow. FWIW I'm with Bountyhunter, 60 psi is awfully low. It might just be a bridge too far. You could also try pouring in some seafoam. It is commonly used to de-carbon rings on two strokes. Maybe some heavy weight oil might give some temporary compression, but be careful trying to crank the motor if there has been very much fluid of any type added to the cylinders. You might bend a rod in the process, thus rendering any efforts as moot.
1978 KZ1000 A2 Click--->Build Thread
2004 ZX-10R
2007 Harley Sportster 1200
2020 Harley Street Glide Special
Angola, IN
2004 ZX-10R
2007 Harley Sportster 1200
2020 Harley Street Glide Special
Angola, IN
Please Log in or Create an account to join the conversation.
- blipco
-
Topic Author
- Offline
- User
-

Registered
- 2002 KZ1000P
- Posts: 556
- Thanks: 212
Re: Most Volatile Mix ???
13 Feb 2012 11:05 - 13 Feb 2012 11:08testarossa wrote: Forgive me for asking, but you haven't stated. Have you verified correct ignition function and timing? Also is the battery at full charge? A lot of newer bikes with computer controlled ignitions won't fire if they are cranking too slow. FWIW I'm with Bountyhunter, 60 psi is awfully low. It might just be a bridge too far. You could also try pouring in some seafoam. It is commonly used to de-carbon rings on two strokes. Maybe some heavy weight oil might give some temporary compression, but be careful trying to crank the motor if there has been very much fluid of any type added to the cylinders. You might bend a rod in the process, thus rendering any efforts as moot.
Yes, ignition and timing is correct. I couldn't get so much as a backfire. I have a car battery hooked up fully charged. I even brought it to a pro motorcycle mechanic of 25 years. He said he almost got it to fire. He thinks if I can get it to start, that alone will loosen the rings to a point where the motor will be back in service. Since then I've been soaking/cranking it. I'm afraid it may need new rings. Now home projects are starting to overwhelm me. This really makes me appreciate the simplicity of my KZP. I'm to the point where I want to sell or part out the project.
"Swim against the current, even a dead fish can go with the flow"-somebody (I forget Who)
Last edit: 13 Feb 2012 11:08 by blipco.
Please Log in or Create an account to join the conversation.
- Motor Head
-
- Offline
- User
-

Registered
- FIX UP YOUR BIKE RIGHT AND CHEAP
- Posts: 5137
- Thanks: 393
Re: Most Volatile Mix ???
13 Feb 2012 11:19
Have you checked the compression with a second gauge to verify? How about a Leak Down Test, done that? If the compression is that low, and you are getting spark and fresh fuel, then maybe the cam timing is off from the crash? Sounds a bit strange but have you checked that? Possibly towing and bump starting might get it to fire, as it will turn over much faster with a tow than with the starter.
I've gotten some old motors to re-fire using ATF down the Carb when cranking, also some starting fluid at the same time.. The ATF helps seal the gaps up, and the starting fluid will be a lot easier to fire amongst the oil. Once it runs again, it may gain some of the compression back, but I doubt it would ever "Correct" itself.
I've gotten some old motors to re-fire using ATF down the Carb when cranking, also some starting fluid at the same time.. The ATF helps seal the gaps up, and the starting fluid will be a lot easier to fire amongst the oil. Once it runs again, it may gain some of the compression back, but I doubt it would ever "Correct" itself.
1982 KZ1000LTD K2 Vance & Hines 4-1 ACCEL COILS Added Vetter fairing & Bags. FOX Racing rear Shocks, Braced Swing-arm, Fork Brace, Progressive Fork Springs RT Gold Emulators, APE Valve Springs, 1166 Big Bore kit, RS34's, GPZ cams.
1980 KZ550LTD C1 Stock SOLD Miss it
1979 MAZDA RX7 in the works, 13B 6 port built/ light flywheel/ 48 DCO Weber LUV IT! Street Legal Go Cart!
1982 KZ1100 A-2 Shaft just bought it in pieces form 1st owner: Now Running Great! SOLD
1990 Concours 1000 Project bike rough body work: Now Running & Riding!
www.kz1000r.com/downloads/Kawasaki%20KZ1...Service%20Manual.pdf
1980 KZ550LTD C1 Stock SOLD Miss it
1979 MAZDA RX7 in the works, 13B 6 port built/ light flywheel/ 48 DCO Weber LUV IT! Street Legal Go Cart!
1982 KZ1100 A-2 Shaft just bought it in pieces form 1st owner: Now Running Great! SOLD
1990 Concours 1000 Project bike rough body work: Now Running & Riding!
www.kz1000r.com/downloads/Kawasaki%20KZ1...Service%20Manual.pdf
Please Log in or Create an account to join the conversation.
- Zedone
-
- Offline
- User
-

Registered
- Posts: 397
- Thanks: 14
Re: Most Volatile Mix ???
13 Feb 2012 11:46
Yes what Tesstorossa said X 12! If you put too much fluid down the combustion chamber and the engine starts you can have Hydrolock" this can be VERY exspensive to repair all the carnage...
The rods in the attached pic are out of a 911 Targa, the fellow did the old "pour some water into the throttlebody trick" and put in too much too fast, I would never try to de-carbon any engine in this manner. But thats just me :laugh:
I had a seized cylinder (on one of my KZ1000') after letting it sit too long without turning the engine over...... I tried everything under the sun to get the bitch freed up and then tried straight deisel fuel (@ 1/2 ounce per cyl.) and let it sit for a couple days, went and tried it again and :woohoo: it worked like a charm. If you do this just make sure to change your oil afterward. I'd throw a compression gauge on there and check just for comfort.
Cheers, Doug
The rods in the attached pic are out of a 911 Targa, the fellow did the old "pour some water into the throttlebody trick" and put in too much too fast, I would never try to de-carbon any engine in this manner. But thats just me :laugh:
I had a seized cylinder (on one of my KZ1000') after letting it sit too long without turning the engine over...... I tried everything under the sun to get the bitch freed up and then tried straight deisel fuel (@ 1/2 ounce per cyl.) and let it sit for a couple days, went and tried it again and :woohoo: it worked like a charm. If you do this just make sure to change your oil afterward. I'd throw a compression gauge on there and check just for comfort.
Cheers, Doug
1977 KZ1000A1
1977 KZ1000A1 (Superbike Project)
1969 Chevrolet C/10 Short Fleet
1977 KZ1000A1 (Superbike Project)
1969 Chevrolet C/10 Short Fleet
Please Log in or Create an account to join the conversation.
- blipco
-
Topic Author
- Offline
- User
-

Registered
- 2002 KZ1000P
- Posts: 556
- Thanks: 212
Re: Most Volatile Mix ???
13 Feb 2012 12:57
Thanks again guys. No leak down test needed. I taped off a crank case vent hose and you can see the crank case pressurize instantly from the blow-by. I didn't think of ATF. I am careful to avoid hydrolock. I'll try the diesel fuel trick next. I have been using the same gauges. I don't know how truly accurate they are but I can at least tell if there is any improvement.
"Swim against the current, even a dead fish can go with the flow"-somebody (I forget Who)
Please Log in or Create an account to join the conversation.
- LarryC
-
- Offline
- User
-

Registered
- Posts: 1241
- Thanks: 309
Re: Most Volatile Mix ???
13 Feb 2012 23:04
WD-40 works great as starting fluid and is less harmful to the valves and cylinders than starting fluid. We always made sure we had a can with us when snowmobiling.
Larry C.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
