Quick question kz650 about case
- idkleine
-
Topic Author
- Offline
- User
-

Registered
- Posts: 52
- Thanks: 0
Quick question kz650 about case
13 Feb 2012 18:42
So I took this thing apart 3 years ago, 3000 miles from here, and assembly is going slow as hell seeing as how I have forgotten a lot of details and lost a few parts. Anyhow it's a 81 KZ650 which I have added a kick start shaft and side cover from an older model. I finally have the clutch basket assembled and just want to know if this large threaded hole in the center of the pic should have something in it or not? I'm thinking not, but am not sure enough to proceed. Also I do have a threaded aluminum plug with a small allen head socket in it that does fit in this hole, but I think it may have been one I replaced with a new one that goes in the oil pan.
Also less importantly my bike has 2 dowel pin holes to align the clutch side cover but had no pins in them originally. I am thinking that is because it did not have a kick starter shaft going through it and therefore precise alignment was not important, but now that I have put a kick starter in, I am going to put in dowel pins just for safe measure. You can see one of the dowel pin holes in the picture below the gear on the right side of the pic. I fortunately found a few that fit from a junk kz1000 case I have laying around. Sounds logical right?
Also less importantly my bike has 2 dowel pin holes to align the clutch side cover but had no pins in them originally. I am thinking that is because it did not have a kick starter shaft going through it and therefore precise alignment was not important, but now that I have put a kick starter in, I am going to put in dowel pins just for safe measure. You can see one of the dowel pin holes in the picture below the gear on the right side of the pic. I fortunately found a few that fit from a junk kz1000 case I have laying around. Sounds logical right?
Please Log in or Create an account to join the conversation.
- OnkelB
-
- Offline
- User
-

Registered
- Posts: 1011
- Thanks: 80
Re: Quick question kz650 about case
13 Feb 2012 18:55idkleine wrote: ... Also I do have a threaded aluminum plug with a small allen head socket in it that does fit in this hole, but I think it may have been one I replaced with a new one that goes in the oil pan.
That plug should be in the hole, marked red in the pic below.
77 KZ 650 B1, 82 GPz 1100 B2.
Please Log in or Create an account to join the conversation.
- idkleine
-
Topic Author
- Offline
- User
-

Registered
- Posts: 52
- Thanks: 0
Re: Quick question kz650 about case
14 Feb 2012 02:45
Got it. Put it in there. I'm taking your word for it. Thanks! One step closer..
Please Log in or Create an account to join the conversation.
- idkleine
-
Topic Author
- Offline
- User
-

Registered
- Posts: 52
- Thanks: 0
Re: Quick question kz650 about case
14 Feb 2012 02:57
My next question is about the cylinder studs. for some reason I was inspired to remove them from the case. I guess for refinishing and what not. Anyhow the book doesn't say much about installing them, like how tight I should crank them in to the case. And if I should use loctite or lube of any kind on the threads. Also I'm totally baffled about why 2 of the studs on one side of the engine have o-rings that seat into the case around the studs and the others don't. Can someone demystify this for me just so I can quit wondering why. Thx
D
D
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
