Cam Degreeing
- DoubleDub
-
Topic Author
- User
-

Public
- Thanks: 0
Cam Degreeing
14 Feb 2012 17:48
This always confused me. I just needed a simple explanation of the process. I know OMR wrote up a document in the file base, but I needed something to "show me" what was being done. I realize this isn't a motorcycle engine or even a Kz engine, but for me it was the best demonstration of how to measure the cam degreeing.
Please Log in or Create an account to join the conversation.
- mark1122
-
- Offline
- User
-

Registered
- Keep twisting it
- Posts: 5297
- Thanks: 109
Re: Cam Degreeing
14 Feb 2012 20:24
I’m not quite sure what u r asking ?
by slightly adjusting the time that the intake and exhaust open or close, u can manipulate the way the motor breaths. this will not give u any miraculous hp gains, but will allow u to move the torque curve a bit, to suit your needs.
U are measuring the valves opening(with the dial indicator) at a particular crank shaft position(measured with the degree wheel). When u buy new cams, the manufacturer gives u a spec sheet. U are only verifying that the cams r indeed at this spec.
some reasons u may want to change the cams position, would be that u want to try a dif spec, or that u may have milled the head, or the cam chain has stretched.
Buy moving the cam on the sprocket (via slotted bolt holes), u are changing the exact time that the valve starts to open.
by slightly adjusting the time that the intake and exhaust open or close, u can manipulate the way the motor breaths. this will not give u any miraculous hp gains, but will allow u to move the torque curve a bit, to suit your needs.
U are measuring the valves opening(with the dial indicator) at a particular crank shaft position(measured with the degree wheel). When u buy new cams, the manufacturer gives u a spec sheet. U are only verifying that the cams r indeed at this spec.
some reasons u may want to change the cams position, would be that u want to try a dif spec, or that u may have milled the head, or the cam chain has stretched.
Buy moving the cam on the sprocket (via slotted bolt holes), u are changing the exact time that the valve starts to open.
76 KZ, frame gusset work,1200CC.Ported by Larry Cavanaugh, 1.5mm.over intakes, Carron Pipe, ZRX12 rear end, and seat,96zx9 front end.
01 CBR600F4i Track bike.
Cobourg, Ont. Can.
~ ~ ~_@
~ ~ _- \,
~ (k) / (z)
01 CBR600F4i Track bike.
Cobourg, Ont. Can.
~ ~ ~_@
~ ~ _- \,
~ (k) / (z)
Please Log in or Create an account to join the conversation.
- DoubleDub
-
Topic Author
- User
-

Public
- Thanks: 0
Re: Cam Degreeing
14 Feb 2012 23:37
Mark - it wasn't a question, I just was always confused by it and this video gave me what I needed - thought I'd share.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
