new ring fitment

  • joe*
  • joe*'s Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • '82 KZ750N
  • Posts: 42
  • Thanks: 0

new ring fitment

15 Feb 2012 16:30
#504198
Haynes says put the piston in the cylinder, put the new ring in the used cylinder, to get the ring exactly perpendicular to the cylinder - push the ring using the piston, measure the gap with the new ring in the unused part (bottom) of the cylinder. I can get the .3 feeler in there - barely this close tolerance with the feeler is only on the fattest (second from the top) ring. Should I file the ring?

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: new ring fitment

15 Feb 2012 16:45
#504202
joe* wrote: Haynes says put the piston in the cylinder, put the new ring in the used cylinder, to get the ring exactly perpendicular to the cylinder - push the ring using the piston, measure the gap with the new ring in the unused part (bottom) of the cylinder. I can get the .3 feeler in there - barely this close tolerance with the feeler is only on the fattest (second from the top) ring. Should I file the ring?

Would heed the FSM, and if needed here's the link to a free downloadable FSM.

Click the link and then scroll down to "The Bible."

kz.bike-night.com/

Good Fortune! :)
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

  • bountyhunter
  • bountyhunter's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 7245
  • Thanks: 338

Re: new ring fitment

15 Feb 2012 16:49
#504206
joe* wrote: Haynes says put the piston in the cylinder, put the new ring in the used cylinder, to get the ring exactly perpendicular to the cylinder - push the ring using the piston, measure the gap with the new ring in the unused part (bottom) of the cylinder. I can get the .3 feeler in there - barely this close tolerance with the feeler is only on the fattest (second from the top) ring. Should I file the ring?
I recall the rule of thumb for ring end gap is .003" per inch of bore diameter. If "0.3" is mm, that's about .012" so it sounds like the right ballpark.
1979 KZ-750 Twin

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum