Typical noob post....wtf
- fizzer_$tfighter
-
Topic Author
- Offline
- User
-

Registered
- YAMASAWKI MAN
- Posts: 60
- Thanks: 0
Typical noob post....wtf
22 Feb 2012 23:37 - 22 Feb 2012 23:39
Ok so my 82 kz1000j is running like complete crap.
It was running ok until about a week ago. I fired it up one day and it kind of sounds like a dirt bike all the sudden.
I took it in a replaced the valvecover gasket (oil leak), change the oil, clean carbs, and change spark plugs.
I put it all back together and its running worse then ever. Cyclinder #4 pipe is hot but not as hot as the others.
It sounds like a damn two stroke, it wouldnt idle (i turned the idle screw up a bit to get it to idle), then it lags and doesnt want to drop the rpms when I let off the th throttle?
This is my daily, and I need it up asap...help me gurus of the kz
Thanks,
Rob
Edit: its still leaking oil on the top of the head? Can it seep through up the head bolts?
It was running ok until about a week ago. I fired it up one day and it kind of sounds like a dirt bike all the sudden.
I took it in a replaced the valvecover gasket (oil leak), change the oil, clean carbs, and change spark plugs.
I put it all back together and its running worse then ever. Cyclinder #4 pipe is hot but not as hot as the others.
It sounds like a damn two stroke, it wouldnt idle (i turned the idle screw up a bit to get it to idle), then it lags and doesnt want to drop the rpms when I let off the th throttle?
This is my daily, and I need it up asap...help me gurus of the kz
Thanks,
Rob
Edit: its still leaking oil on the top of the head? Can it seep through up the head bolts?
82 KZ 1000 J Model
Last edit: 22 Feb 2012 23:39 by fizzer_$tfighter. Reason: Forgot details
Please Log in or Create an account to join the conversation.
- roy-b-boy-b
-
- Offline
- User
-

Registered
- Posts: 3245
- Thanks: 103
Re: Typical noob post....wtf
22 Feb 2012 23:39
Have you checked to see if you have a good fuel flow? Has it been sitting for any amount of time? Roy
1979 LTD Street Fighter.1977 KZ1000
Please Log in or Create an account to join the conversation.
- fizzer_$tfighter
-
Topic Author
- Offline
- User
-

Registered
- YAMASAWKI MAN
- Posts: 60
- Thanks: 0
Re: Typical noob post....wtf
22 Feb 2012 23:44
Before I bought it in december it was sittkng for quite awhile. And as far as fuel it drinks the shit....
82 KZ 1000 J Model
Please Log in or Create an account to join the conversation.
- roy-b-boy-b
-
- Offline
- User
-

Registered
- Posts: 3245
- Thanks: 103
Re: Typical noob post....wtf
22 Feb 2012 23:48
So it has fresh gas? You need check everything. There might be a manual in the download section.
Check for twelve volts to the coils.
Left coil 1and4 sparl plug wire. right coil 2and3. Check the timing advancer to make sure it is not stuck. Roy
Check for twelve volts to the coils.
Left coil 1and4 sparl plug wire. right coil 2and3. Check the timing advancer to make sure it is not stuck. Roy
1979 LTD Street Fighter.1977 KZ1000
Please Log in or Create an account to join the conversation.
- fizzer_$tfighter
-
Topic Author
- Offline
- User
-

Registered
- YAMASAWKI MAN
- Posts: 60
- Thanks: 0
Re: Typical noob post....wtf
22 Feb 2012 23:54
Ok. Thanks Roy
Ill check it friday on my next day off. Waiting for my clymer manual to get in.
Ill check it friday on my next day off. Waiting for my clymer manual to get in.
82 KZ 1000 J Model
Please Log in or Create an account to join the conversation.
- KZJOE900
-
- Offline
- Administrator
-

Super Users
- Posts: 1984
- Thanks: 455
Re: Typical noob post....wtf
23 Feb 2012 00:07
Might try to check the tachometer cable at the head for the oil leak. Very common on KZ's. As for #4 cylinder, you can try checking the intake boot (between the carburetor and the cylinder head) for air leaks. You can do this by spraying starting fluid (or unlit butane torch) around the boot when the engine is at low idle and see if the rpm's change. At least these are fast easy checks
Current project 76 KZ900 (This was a Vetter model)
76 KZ900
81 XJ550H SECA (Current Project)
82 XJ550R SECA
Past:
86 FJ1200
74 Z1900
72 CB450
76 KZ900
81 XJ550H SECA (Current Project)
82 XJ550R SECA
Past:
86 FJ1200
74 Z1900
72 CB450
The following user(s) said Thank You: fizzer_$tfighter
Please Log in or Create an account to join the conversation.
- jeffasaki
-
- Offline
- User
-

Registered
- Posts: 996
- Thanks: 44
Re: Typical noob post....wtf
23 Feb 2012 00:21
sounds like a timming issue to me
check your points as well as the advancer behind them
if all these check out ok then id look at all connecters
in the harness
actually check all these anyway
especially the one comming from the
alternator
they run from the bottom through the output shaft assy cover
they are prone to failure in this area
check your points as well as the advancer behind them
if all these check out ok then id look at all connecters
in the harness
actually check all these anyway
especially the one comming from the
alternator
they run from the bottom through the output shaft assy cover
they are prone to failure in this area
78 Z1R
78 KZ1000
76 KH500 gone
71 HS1B 90
81 GS 1100 gone
80 PE400
02 KLR
Ontario Canada
78 KZ1000
76 KH500 gone
71 HS1B 90
81 GS 1100 gone
80 PE400
02 KLR
Ontario Canada
Please Log in or Create an account to join the conversation.
- fizzer_$tfighter
-
Topic Author
- Offline
- User
-

Registered
- YAMASAWKI MAN
- Posts: 60
- Thanks: 0
Re: Typical noob post....wtf
24 Feb 2012 11:15
Well my bike mech buddy is thinking the vacuum issue, suggested what kzjoe did with the rubber boots!
I know those are bad so time to replace those.
He said he also noticed some air bubbles coming up from the oil (leak) around the spark plug on #4.
Apparently I need to recheck the torque on those, and add some new crush washers.
I know those are bad so time to replace those.
He said he also noticed some air bubbles coming up from the oil (leak) around the spark plug on #4.
Apparently I need to recheck the torque on those, and add some new crush washers.
82 KZ 1000 J Model
Please Log in or Create an account to join the conversation.
- Kawickrice
-
- Offline
- User
-

Registered
- After Monday & Tuesday, even the calendar says WTF
- Posts: 2469
- Thanks: 20
Re: Typical noob post....wtf
24 Feb 2012 20:01
Is the valve cover leaking causing oil to leak down on the #4 plug, or is the oil leak coming OUT of the spark plug hole?
73 Kawasaki Z1
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
The following user(s) said Thank You: BlackZ1R
Please Log in or Create an account to join the conversation.
- fizzer_$tfighter
-
Topic Author
- Offline
- User
-

Registered
- YAMASAWKI MAN
- Posts: 60
- Thanks: 0
Re: Typical noob post....wtf
25 Feb 2012 14:06
From what I know the oil is leaking from some unidentified spot. And its pooling around #4 plug. While running you can see some bubbles coming from the pool. I didbt have a torque wrench when I did the plugs, so thats probably just not down tight. Im going to get some crush washers snd index my plugs anyway, and pick a torque wrench up.
82 KZ 1000 J Model
Please Log in or Create an account to join the conversation.
- Kawickrice
-
- Offline
- User
-

Registered
- After Monday & Tuesday, even the calendar says WTF
- Posts: 2469
- Thanks: 20
Re: Typical noob post....wtf
25 Feb 2012 14:54
Get the motor cleaned up and it is easier to trace leaks. If you have a hard time determining where the leak is clean the motor and get an aerosol can of athletes foot powder and spray it around the gaskets you suspect, then run the motor and watch the area you suspect. The leaking oil will make the white powder disappear and that will identify where the leak is. If the oil is coming from above the spark plug it is most likely a valve cover gasket or possibly the half moon plugs between the head and valve cover
73 Kawasaki Z1
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
07 HD CVO Ultra Classic
82 Suzuki GS 1100
74 Yamaha RD 350 (My two stroke toy)
77 Kawasaki KZ 650B-1 (My putt around bike)
80 Indian Moped (My American Iron)
1
Long Gone
75 Suzuki GT550
74 GT 380
79 RD 400 Daytona Special
72 Honda CL 175
74 Honda QA 50
Tampa FL
The following user(s) said Thank You: fizzer_$tfighter
Please Log in or Create an account to join the conversation.
- fizzer_$tfighter
-
Topic Author
- Offline
- User
-

Registered
- YAMASAWKI MAN
- Posts: 60
- Thanks: 0
Re: Typical noob post....wtf
29 Feb 2012 15:10
Oil is coming from stupid cam end plug...and possibly the head gasket, still have to check the tach line.
I dont know what im looking for on the timing issue, so waiting on my clymer.
I dont know what im looking for on the timing issue, so waiting on my clymer.
82 KZ 1000 J Model
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
