How often do your clutch cables break?
- Mike Mecredy
-
Topic Author
- Offline
- User
-

Registered
- Posts: 25
- Thanks: 1
How often do your clutch cables break?
22 Mar 2012 11:30
I've broken 2 clutch cables on my KZ 1000P within the last 10,000 miles. Have anyone else experienced this? Do you know a source for better clutch cables? would too much end play cause it? I'm mechanical but this has me stumped.
On both the they broke at the cable stop on the grip end. I've got a new one from Z-1, but while I was waiting for it to get here I took some 5/16" round steel stock, drilled holes, one for a stop screw and one for the cable, I had the cable protrude outthe end about .100" and I welded it, AND installed the stop screw. It is stronger than a new one now, but I'm just baffled that that break that much. It's not a hard clutch.
On both the they broke at the cable stop on the grip end. I've got a new one from Z-1, but while I was waiting for it to get here I took some 5/16" round steel stock, drilled holes, one for a stop screw and one for the cable, I had the cable protrude outthe end about .100" and I welded it, AND installed the stop screw. It is stronger than a new one now, but I'm just baffled that that break that much. It's not a hard clutch.
1997 KZ1000 police
Please Log in or Create an account to join the conversation.
- Mcdroid
-
- Offline
- Sustaining Member
-

Registered
- Gone Kwackers
- Posts: 6909
- Thanks: 530
Re: How often do your clutch cables break?
22 Mar 2012 11:42
That break point of yours is typical. I have gone through clutch cables every 10,000 miles (or less)...because I formerly did no maintenance (= lubrication) on my cables. I pay more attention now.
Michael
Victoria, Texas
1982 GPz750
1977 KZ1000A
1978 KZ1000A
1982 GPz1100
1975 Z2A
Victoria, Texas
1982 GPz750
1977 KZ1000A
1978 KZ1000A
1982 GPz1100
1975 Z2A
Please Log in or Create an account to join the conversation.
- 650ed
-
- Offline
- User
-

Registered
- Posts: 15334
- Thanks: 2832
Re: How often do your clutch cables break?
22 Mar 2012 11:49 - 22 Mar 2012 11:52
I have never had one break on my Kawasaki. I replaced the original with another NOS cable at 44,000 miles, but that was for cosmetic not functional reasons. Make sure the cable is lubed before installing then re-lube every year or two. Be sure to adjust it according to the manual. Also, check to see if there is a sharp bend of anything rubbing where your cables have broken. A sharp bend was a problem on my old BSA and cables didn't like it. If possible, find a NOS Kawasaki cable; sometimes they show up on eBay; they seem to last forever with just occasional maintenance. The cable play between the lever and the bracket should be 2 - 3 mm. Ed
1977 KZ650-C1 Original Owner - Stock (with additional invisible FIAMM horn)
Last edit: 22 Mar 2012 11:52 by 650ed.
Please Log in or Create an account to join the conversation.
- loudhvx
-
- Offline
- KZr Legend
-

Registered
- Posts: 10863
- Thanks: 1622
Re: How often do your clutch cables break?
22 Mar 2012 13:34
Like Ed said, make sure the cable and housing go straight into the lever assembly. If the cable/housing starts to bend right at the point where it goes into the adjuster it can wear much faster.
Also it should be lubed about once a year.
the factory ones seem to last longer than aftermarket ones, but aftermarket ones should last longer than 10,000 miles.
Also it should be lubed about once a year.
the factory ones seem to last longer than aftermarket ones, but aftermarket ones should last longer than 10,000 miles.
1981 KZ550 D1 gpz.
Kz550 valve train warning.
Other links.
Kz550 valve train warning.
Other links.
Please Log in or Create an account to join the conversation.
- RonKZ650
-
- Offline
- User
-

Registered
- Posts: 3719
- Thanks: 252
Re: How often do your clutch cables break?
22 Mar 2012 13:55
Of course if you do all highway riding they will last for 100,000 miles or more. City stop/go considerably less. 10-15 thousand or 20,000 at most using stock Kawasaki cable, 5-10 thousand with Motion Pro, maybe 15,000 if you're lucky. They will always break at the ball at the lever. I don't think lube will help a lot, I've lubed and not lubed over the years and they break either way eventually at the lever.
321,000 miles on KZ's that I can remember. Not going to see any more.
Please Log in or Create an account to join the conversation.
- WABBMW
-
- Offline
- User
-

Registered
- Let The Good Times Roll !
- Posts: 341
- Thanks: 16
Re: How often do your clutch cables break?
22 Mar 2012 14:07
The lubrication method I use, is to detach the cable from the lever, and turn it upward as high as possible. Then I use an oil can filled with SAE 90 weight gear oil, and drip oil onto the cable so it can run down inside the housing. Continue this for several hours, while doing other tasks in the garage. Finish up by putting grease on the cable where it enters the housing.
Also, be sure that the cable is secured to the frame as far from the hot headers as possible. Be sure the routing of the cable is so that bends are through as large a radius as possible.
If you ever have the mechanism apart that exerts force against the pushrod, (on the lower end of the cable), then clean and lubricate the balls and ramps well.
I have never had a cable to break in 31,000 miles, but did take a spare cable on a long trip, since it would be such a problem if it breaks on the road. Not bad on the highway, but not good when going through large, unknown metropolitan areas. Good luck.
Also, be sure that the cable is secured to the frame as far from the hot headers as possible. Be sure the routing of the cable is so that bends are through as large a radius as possible.
If you ever have the mechanism apart that exerts force against the pushrod, (on the lower end of the cable), then clean and lubricate the balls and ramps well.
I have never had a cable to break in 31,000 miles, but did take a spare cable on a long trip, since it would be such a problem if it breaks on the road. Not bad on the highway, but not good when going through large, unknown metropolitan areas. Good luck.
Bill Baker
Houston, Texas
1982 KZ650 CSR
2008 Yamaha FZ1
2006 Yamaha FZ1
1977 Honda Supersport 750 four (sold)
1984 Honda Nighthawk 650 (sold)
Houston, Texas
1982 KZ650 CSR
2008 Yamaha FZ1
2006 Yamaha FZ1
1977 Honda Supersport 750 four (sold)
1984 Honda Nighthawk 650 (sold)
Please Log in or Create an account to join the conversation.
- loudhvx
-
- Offline
- KZr Legend
-

Registered
- Posts: 10863
- Thanks: 1622
Re: How often do your clutch cables break?
22 Mar 2012 14:48
Well, maybe the lube depends on where you live. Around here anything steel is gonna rust if not oiled. Even if you don't get caught in the rain, everything is damp as hell in the spring and fall.
I also use the 90 weight.
I poke the cable through a sandwich bag, then electrical tape it to seal it to the cable, then put a couple tablespoons of oil in the bag and let it sit for an hour.
I also use the 90 weight.
I poke the cable through a sandwich bag, then electrical tape it to seal it to the cable, then put a couple tablespoons of oil in the bag and let it sit for an hour.
1981 KZ550 D1 gpz.
Kz550 valve train warning.
Other links.
Kz550 valve train warning.
Other links.
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: How often do your clutch cables break?
22 Mar 2012 15:58
Try these website for cables:
Control Cables
www.motionpro.com
www.barnettclutches.com/
www.terrycable.com (I understand these cables are Teflon lined for low friction)
www.flandersco.com/FlanCableSearch.html
www.phatperformanceparts.com/Cables_s/587200.htm
Control Cables
www.motionpro.com
www.barnettclutches.com/
www.terrycable.com (I understand these cables are Teflon lined for low friction)
www.flandersco.com/FlanCableSearch.html
www.phatperformanceparts.com/Cables_s/587200.htm
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- 650ed
-
- Offline
- User
-

Registered
- Posts: 15334
- Thanks: 2832
Re: How often do your clutch cables break?
22 Mar 2012 20:38
I would try a Genuine Kawasaki cable and compare it to your experience with Motion-Pro. You can still buy the stock cable from any dealer - it is listed as an "Active" part. Ed
1977 KZ650-C1 Original Owner - Stock (with additional invisible FIAMM horn)
Please Log in or Create an account to join the conversation.
- Jeff.Saunders
-
- Offline
- Vendor
-

Vendors
- Posts: 1238
- Thanks: 149
Re: How often do your clutch cables break?
22 Mar 2012 20:57 - 22 Mar 2012 20:58
Rarely is the problem the cable...
...and as others mentioned, make sure you lube the cable.
- Check the adjuster to make sure there are no sharp edges.
- Make sure the cable is routed correctly. It should exit fairly stright from the clutch perch.
- Make sure the hole in the lever where the cable barrel pivots is not damaged or wron badly. If the barrel cannot rotate in that hole, the cable will break quickly.
...and as others mentioned, make sure you lube the cable.
Last edit: 22 Mar 2012 20:58 by Jeff.Saunders.
Please Log in or Create an account to join the conversation.
- Motor Head
-
- Offline
- User
-

Registered
- FIX UP YOUR BIKE RIGHT AND CHEAP
- Posts: 5137
- Thanks: 393
Re: How often do your clutch cables break?
22 Mar 2012 21:58
Check the adjuster sleeve at the Lever, it may have a sharp edge or burr. This will lead to fraying and then breaking. Also when replacing the cable, on the inside of the sprocket side cover, remove and lube the pivot mechanism.
The manual in my signature will cover this.
The manual in my signature will cover this.
1982 KZ1000LTD K2 Vance & Hines 4-1 ACCEL COILS Added Vetter fairing & Bags. FOX Racing rear Shocks, Braced Swing-arm, Fork Brace, Progressive Fork Springs RT Gold Emulators, APE Valve Springs, 1166 Big Bore kit, RS34's, GPZ cams.
1980 KZ550LTD C1 Stock SOLD Miss it
1979 MAZDA RX7 in the works, 13B 6 port built/ light flywheel/ 48 DCO Weber LUV IT! Street Legal Go Cart!
1982 KZ1100 A-2 Shaft just bought it in pieces form 1st owner: Now Running Great! SOLD
1990 Concours 1000 Project bike rough body work: Now Running & Riding!
www.kz1000r.com/downloads/Kawasaki%20KZ1...Service%20Manual.pdf
1980 KZ550LTD C1 Stock SOLD Miss it
1979 MAZDA RX7 in the works, 13B 6 port built/ light flywheel/ 48 DCO Weber LUV IT! Street Legal Go Cart!
1982 KZ1100 A-2 Shaft just bought it in pieces form 1st owner: Now Running Great! SOLD
1990 Concours 1000 Project bike rough body work: Now Running & Riding!
www.kz1000r.com/downloads/Kawasaki%20KZ1...Service%20Manual.pdf
Please Log in or Create an account to join the conversation.
- dejavoodo41
-
- Offline
- User
-

Registered
- Posts: 405
- Thanks: 14
Re: How often do your clutch cables break?
22 Mar 2012 22:30
I've had 3 cables break in the last 3 years. All of them broke in the same spot by the lever and it turned out that there was a groove worn in the adjuster that was wearing on the cable. I replaced the adjuster, lubed up a new cable and it's been good to go ever since.
1977 KZ1000A With 1980 KZ1000A MKII engine, Wiseco 1105 kit, Dyna S Ignition, 3 Ohm Dyna Coils, Cams, Mikuni RS34 Carbs, Vance and Hines Pro Pipe with Comp Baffle
New Smyrna Beach, FL
New Smyrna Beach, FL
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
