Cam Chain Tensioner

  • blipco
  • blipco's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • 2002 KZ1000P
  • Posts: 556
  • Thanks: 212

Cam Chain Tensioner

30 Apr 2012 20:08
#518882
I have removed my valve cover on my J motor. To reinstall it I took the cap off the cam chain tensioner to allow the cross wedge to relax so that the chain is properly tensioned.
Is this all I need to do? With the cap off I could press the the cam chain down though it took some force and would spring back into position once I let it go. At first it wouldn't do that, it would stay pushed down but after I greased the removable part of the wedge it seams to have freed up. How can I tell if it is working properly? I've been searching but cannot get a clear answer. Mark.
"Swim against the current, even a dead fish can go with the flow"-somebody (I forget Who)

Please Log in or Create an account to join the conversation.

  • zed1015
  • zed1015's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 3376
  • Thanks: 2087

Re: Cam Chain Tensioner

30 Apr 2012 20:39
#518890
Yes! everything you have done is correct and is all you need to do.
The spring loaded wedge usually needs a bit of help to un-jam and release the tension.
Re-fit the cover then refit the tensioner wedge,spring and cap
Just don't rotate the engine without the tensioner re-installed as the camchain could jump on the crank teeth as i'm sure you already know.
AIR CORRECTOR JETS FOR VM CARBS AND ETHANOL RESISTANT VITON CHOKE PLUNGER SEAL REPLACMENT FOR ALL CLASSIC AND MODERN MOTORCYCLE CARBURETTORS
www.kzrider.com/forum/23-for-sale/611992...lide-mikunis?start=1






Please Log in or Create an account to join the conversation.

  • blipco
  • blipco's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • 2002 KZ1000P
  • Posts: 556
  • Thanks: 212

Re: Cam Chain Tensioner

30 Apr 2012 22:35
#518922
zed1015 wrote: Yes! everything you have done is correct and is all you need to do.
The spring loaded wedge usually needs a bit of help to un-jam and release the tension.
Re-fit the cover then refit the tensioner wedge,spring and cap
Just don't rotate the engine without the tensioner re-installed as the camchain could jump on the crank teeth as i'm sure you already know.

Yes, thank you Zed. I have it back together already. No turning crank without tensioner together.
"Swim against the current, even a dead fish can go with the flow"-somebody (I forget Who)

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum