Gasket change out

  • Freekz1000
  • Freekz1000's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 9
  • Thanks: 0

Gasket change out

19 Dec 2012 12:13
#563669
I recently acquired a 1978 kz1000 from my neighbor and it is stripped down ready to be restored. The tach reads 7500 miles, it runs good. Should I get a gasket kit and replace the gaskets since it would be easy to do while the motor is out? Or should I leave well enough alone since I don't see any obvious leaks or problems. It wasn't ran for three or four years and I got it going and put fresh oil in it. It runs smooth. Please advise.

Please Log in or Create an account to join the conversation.

  • KZJOE900
  • KZJOE900's Avatar
  • Offline
  • Administrator
  • Administrator
    Super Users
  • Posts: 1984
  • Thanks: 455

Re: Gasket change out

19 Dec 2012 12:31
#563672
Personally, with only 7500 mi. and only sat for 3 or 4 yrs and the bike runs good with no leaks, then I say leave well enough alone. But I would definitely do a compression test followed by a at least a crude leak down test (if the compression is low) to base my decision on. And if the compression tests warrants a tear down. Then yes, cheapest way to go is to buy the whole gasket kit.
Current project 76 KZ900 (This was a Vetter model)
76 KZ900
81 XJ550H SECA (Current Project)
82 XJ550R SECA
Past:
86 FJ1200
74 Z1900
72 CB450

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum