79 kz650 Engine Start Problem
- BoomerX
-
Topic Author
- Offline
- User
-

Registered
- Posts: 17
- Thanks: 0
79 kz650 Engine Start Problem
08 Mar 2010 18:03 - 08 Mar 2010 18:04
The Engine is for my Project Bike.
Cleaned Carbs
New Coils
New Plugs
Points are gapped
New Oil
Its sparking, Seems to have good compression, and its getting fuel. Getting the odd kick outta the exhaust and once and while a backfire through the carbs.
It Will not fire up though.
Not really sure where to go from here.
Cleaned Carbs
New Coils
New Plugs
Points are gapped
New Oil
Its sparking, Seems to have good compression, and its getting fuel. Getting the odd kick outta the exhaust and once and while a backfire through the carbs.
It Will not fire up though.
Not really sure where to go from here.
79' KZ650
Last edit: 08 Mar 2010 18:04 by BoomerX.
Please Log in or Create an account to join the conversation.
- 650ed
-
- Offline
- User
-

Registered
- Posts: 15334
- Thanks: 2832
Re: 79 kz650 Engine Start Problem
08 Mar 2010 18:12
Be sure to have choke on and don't touch the throttle.
1977 KZ650-C1 Original Owner - Stock (with additional invisible FIAMM horn)
Please Log in or Create an account to join the conversation.
- anarki650
-
- Offline
- User
-

Registered
- Posts: 683
- Thanks: 5
Re: 79 kz650 Engine Start Problem
08 Mar 2010 18:20
Steps to ensure everything is dialed in:
1. Check compression. If you don't have good compression you're never going to get her running right.
2. Check valve clearances. Again, if these aren't in spec you're going to have a hell of a time.
3. Set timing (also make sure points are up to snuff, gapped correctly, and have proper dwell...or switch to electronic ignition).
4. Make sure you don't have any leaks around carb holders. If your carb holders are leaking she's going to run like a turd (if at all).
5. Start her up. Time with a timing light and fine tune carbs.
1. Check compression. If you don't have good compression you're never going to get her running right.
2. Check valve clearances. Again, if these aren't in spec you're going to have a hell of a time.
3. Set timing (also make sure points are up to snuff, gapped correctly, and have proper dwell...or switch to electronic ignition).
4. Make sure you don't have any leaks around carb holders. If your carb holders are leaking she's going to run like a turd (if at all).
5. Start her up. Time with a timing light and fine tune carbs.
09 Kawasaki ER6n
77 kz650b1 cafe rebirth project
"Being shot out of a cannon will always be better than being squeezed out of a tube, that's why God made fast motorcycles..."
Dr. Hunter S. Thompson
Omaha NE
77 kz650b1 cafe rebirth project
"Being shot out of a cannon will always be better than being squeezed out of a tube, that's why God made fast motorcycles..."
Dr. Hunter S. Thompson
Omaha NE
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: 79 kz650 Engine Start Problem
08 Mar 2010 18:56
Did you replace the sparkplug caps? they contain a resistor to limit the RFI(the snap and pop heard on radio's when sparkplugs fire)and will fail with heat and age.
They screw onto the sparkplug wires with the normal right hand thread(left to loosen, right to tighten.
They screw onto the sparkplug wires with the normal right hand thread(left to loosen, right to tighten.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- BoomerX
-
Topic Author
- Offline
- User
-

Registered
- Posts: 17
- Thanks: 0
Re: 79 kz650 Engine Start Problem
08 Mar 2010 19:11
caps have been replaced when the plugs were
79' KZ650
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: 79 kz650 Engine Start Problem
08 Mar 2010 19:23
BoomerX wrote:
If not already done, would:
Check ign timing (static method);
Assure quality of fuel;
Try starting fluid.
Good Fortune!
The Engine is for my Project Bike.
Cleaned Carbs
New Coils
New Plugs
Points are gapped
New Oil
Its sparking, Seems to have good compression, and its getting fuel. Getting the odd kick outta the exhaust and once and while a backfire through the carbs.
It Will not fire up though.
Not really sure where to go from here.
If not already done, would:
Check ign timing (static method);
Assure quality of fuel;
Try starting fluid.
Good Fortune!
1973 Z1
KZ900 LTD
KZ900 LTD
Please Log in or Create an account to join the conversation.
- MFolks
-
- Offline
- User
-

Registered
- Posts: 6650
- Thanks: 541
Re: 79 kz650 Engine Start Problem
08 Mar 2010 20:16
Checked the input voltage to the coils? it should be the same as the battery.
For some reason Kawasaki has the smaller 4's ignition coils fire the plugs different from the bigger 4's.
On my 82 GPz1100 B2 the left ignition coil fires # 1 and # 4 with the primary(small wires) being RED and BLACK.
The right coil fires # 2 and # 3 with the primary wires being RED and Green. Take this as a reference not as a fact, but check the wiring from the coils.
For some reason Kawasaki has the smaller 4's ignition coils fire the plugs different from the bigger 4's.
On my 82 GPz1100 B2 the left ignition coil fires # 1 and # 4 with the primary(small wires) being RED and BLACK.
The right coil fires # 2 and # 3 with the primary wires being RED and Green. Take this as a reference not as a fact, but check the wiring from the coils.
1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)
Please Log in or Create an account to join the conversation.
- Old Man Rock
-
- Offline
- User
-

Registered
- Posts: 6071
- Thanks: 225
Re: 79 kz650 Engine Start Problem
09 Mar 2010 04:34
I know this is going to sound weird but it does happen...
Are you sure you have the coil pairs to cylinders correct?
Actually happened to me where in my haste, I had 3&4 plug wires crossed, carbs popped like a sonsabitch... :blush: :laugh: :laugh: Seriously, it does occur...
Just a thought...
OMR
Are you sure you have the coil pairs to cylinders correct?
Actually happened to me where in my haste, I had 3&4 plug wires crossed, carbs popped like a sonsabitch... :blush: :laugh: :laugh: Seriously, it does occur...
Just a thought...
OMR
1976 KZ900-A4
MTC 1075cc.
Camshafts: Kawi GPZ-1100 .375 lift
Head: P&P via Larry Cavanaugh
ZX636 suspension
MIKUNI, RS-34'S...
Kerker 4-1, 1.5" comp baffle.
Dyna-S E.I.
Earls 10 row Oil Cooler
Acewell 2802 Series Speedo/Tach
Innovate LC1 Wideband 02 AFR meter
Phoenix, Az
MTC 1075cc.
Camshafts: Kawi GPZ-1100 .375 lift
Head: P&P via Larry Cavanaugh
ZX636 suspension
MIKUNI, RS-34'S...
Kerker 4-1, 1.5" comp baffle.
Dyna-S E.I.
Earls 10 row Oil Cooler
Acewell 2802 Series Speedo/Tach
Innovate LC1 Wideband 02 AFR meter
Phoenix, Az
Please Log in or Create an account to join the conversation.
- BSKZ650
-
- Offline
- User
-

Registered
- Posts: 2061
- Thanks: 14
Re: 79 kz650 Engine Start Problem
09 Mar 2010 05:11
Old Man Rock wrote:
was gonna say the same thing,, cross wired
I know this is going to sound weird but it does happen...
Are you sure you have the coil pairs to cylinders correct?
Actually happened to me where in my haste, I had 3&4 plug wires crossed, carbs popped like a sonsabitch... :blush: :laugh: :laugh: Seriously, it does occur...
Just a thought...
OMR
was gonna say the same thing,, cross wired
77 kz650, owned for over 25 years
77 ltd1000, current rider
76 kz900, just waiting
73 z1,, gonna restore this one
piglet, leggero harley davidson
SR, Ride captian, S.E.Texas Patriot Guard Riders.. AKA KawaBob
77 ltd1000, current rider
76 kz900, just waiting
73 z1,, gonna restore this one
piglet, leggero harley davidson
SR, Ride captian, S.E.Texas Patriot Guard Riders.. AKA KawaBob
Please Log in or Create an account to join the conversation.
- BoomerX
-
Topic Author
- Offline
- User
-

Registered
- Posts: 17
- Thanks: 0
Re: 79 kz650 Engine Start Problem
09 Mar 2010 06:55
I swapped wires just incase. made it worse.
But I will double and triple check that again.
Gonna check Valve Clearances and do a static Timing test tonight.
But I will double and triple check that again.
Gonna check Valve Clearances and do a static Timing test tonight.
79' KZ650
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Re: 79 kz650 Engine Start Problem
09 Mar 2010 07:17 - 09 Mar 2010 07:17
Be certain to use the F
mark for ignition timing, and ignore the T mark.
Sometimes it isn't abundantly clear as to exactly which mark on the advancer is the F mark.
So be sure about exactly which mark is indeed the F mark.
For example, various advancers on the large fours have differing marks, depending on the particular advancer involved.
Some FSM's will include a photograph of the F mark aligned with the permanent case mark. However, some FSMs cover several model years, and may show a photograph of an earlier model advancer which is slightly different from the advancer actually being seen on the bike at hand.
Good Luck!
Sometimes it isn't abundantly clear as to exactly which mark on the advancer is the F mark.
So be sure about exactly which mark is indeed the F mark.
For example, various advancers on the large fours have differing marks, depending on the particular advancer involved.
Some FSM's will include a photograph of the F mark aligned with the permanent case mark. However, some FSMs cover several model years, and may show a photograph of an earlier model advancer which is slightly different from the advancer actually being seen on the bike at hand.
Good Luck!
1973 Z1
KZ900 LTD
KZ900 LTD
Last edit: 09 Mar 2010 07:17 by Patton.
Please Log in or Create an account to join the conversation.
- Patton
-
- Offline
- KZr Legend
-

Registered
- Posts: 18564
- Thanks: 2103
Last edit: 09 Mar 2010 07:35 by Patton.
Please Log in or Create an account to join the conversation.
Moderators: Street Fighter LTD
