Lacking power, and running rough? Help

  • Dylansword
  • Dylansword's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 32
  • Thanks: 0

Lacking power, and running rough? Help

02 Oct 2010 11:08 - 02 Oct 2010 17:12
#403403
Hello, I picked up a 1977 kz650. It sat for a couple months, i got it running, with carb cleaner and new gas. It ran great for about 50 miles, then it started missing and not running right. I cleaned the carbs, and put new plugs in it, and its still not running good. I have to give it gas to start it, and then it backfires, and smokes black. I suspect the timing now. So my qestion it, what are the timing marks? Or what may it be? Thank you very much.
Last edit: 02 Oct 2010 17:12 by Dylansword.

Please Log in or Create an account to join the conversation.

  • gd4now
  • gd4now's Avatar
  • Offline
  • User
  • User
    Registered
  • Denco where did you go?
  • Posts: 1724
  • Thanks: 711

Re: Timing marks on 77 kz650?

02 Oct 2010 14:14
#403440
You need to get a manual which will have this info in it. You may also want to check out this site forums.kz650.info/index.php?topic=4490.0 as it has lots of info on the kz650s
1977 KZ650 B1
Pods and Denco header


OLD KAW OWNERS SMILE ALOT

Please Log in or Create an account to join the conversation.

  • Dylansword
  • Dylansword's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 32
  • Thanks: 0

Re: Timing marks on 77 kz650?

02 Oct 2010 16:28
#403472
Ok, so i found a manual online. and checked the timing marks, and they were good. Now it will start right up. But, back fires, and smokes black when it backfires. and sometimes on startup. I now thing it is something with thte ignition. It has accel coils, and wires, and dana s ignition. also, 4-1 exhaust. Any ideas?

Please Log in or Create an account to join the conversation.

  • 650ed
  • 650ed's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 15334
  • Thanks: 2832

Re: Timing marks on 77 kz650?

02 Oct 2010 16:31
#403477
If it ran great fo 50 miles I don't see how the timing would be the issue. Sounds like carbs or possibly just bad gas. I would drain fuel and put in new fuel along with a fuel filter. If that doesn't do it, I would clean the carbs again very carefully. Otherwise, if you mess with the timing and it's a fuel problem you will end up with a fuel problem and a timing problem. Ed
1977 KZ650-C1 Original Owner - Stock (with additional invisible FIAMM horn)

Please Log in or Create an account to join the conversation.

  • Patton
  • Patton's Avatar
  • Offline
  • KZr Legend
  • KZr Legend
    Registered
  • Posts: 18564
  • Thanks: 2103

Re: Timing marks on 77 kz650?

02 Oct 2010 16:33
#403482
Dylansword wrote:
...backfires....

Too tight intake valve clearance is one possible cause of backfiring through carb.

Good Fortune! :)
1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

  • Dylansword
  • Dylansword's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 32
  • Thanks: 0

Re: Timing marks on 77 kz650?

02 Oct 2010 17:10
#403497
OK, so now, itit starts and runs. When i drive it, it has no power. With the timing all the way advanced, it doesnt back fire almost at all. It started this, after i hot rodded it. Could somehting in the ignition system have blown. As i said, it has dyna s ignitor, and accel coils and 8mm wires. It was a sudden thing, at first it felt like it was only running on 3 cylinders, and sounded like it to. Ive cleaed the carbs twice. Could all it is, is a clogged carb? Or the dyna ignition? Or the coils? Oh, and it did it once, then seemed to clear up for the ride home, then started after i hot rodded it again. Thanks

Please Log in or Create an account to join the conversation.

  • Dylansword
  • Dylansword's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 32
  • Thanks: 0

Re: Timing marks on 77 kz650?

02 Oct 2010 18:08
#403524
I got my timing light on it, and if its advanced all the way, the still dont line up. And of course get even further away as i retard it. Could something faulty in the ignition system cause, backfiring, black smoke, carbonated plugs, lacking of power, and general running rough? If so, what could be causing it? Thanks

Please Log in or Create an account to join the conversation.

  • keith1
  • keith1's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 1646
  • Thanks: 3

Re: Timing marks on 77 kz650?

02 Oct 2010 19:11 - 02 Oct 2010 19:22
#403566
check the voltage to the coils....make sure you have a good battery.........get a cheap multi -meter and rev the bike to 4k and put the terminals on and see what ya get....should be getting 14 and change....anything less than high 13's and i d be looking at the stator and/or regulator rectifier.......if the bike has less than say 12k,my money would be on the reg/rect.....good luck
Last edit: 02 Oct 2010 19:22 by keith1.

Please Log in or Create an account to join the conversation.

  • Dylansword
  • Dylansword's Avatar Topic Author
  • Offline
  • User
  • User
    Registered
  • Posts: 32
  • Thanks: 0

Re: Timing marks on 77 kz650?

02 Oct 2010 19:47
#403596
ok, i will. It has almost 20k on it. It has a new battery and rectifier. (so the guy i bought it from said) Ill check and get back to you. Thanks

Please Log in or Create an account to join the conversation.

  • bountyhunter
  • bountyhunter's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 7245
  • Thanks: 338

Re: Lacking power, and running rough? Help

02 Oct 2010 19:52 - 02 Oct 2010 19:52
#403598
Dylansword wrote:
Hello, I picked up a 1977 kz650. It sat for a couple months, i got it running, with carb cleaner and new gas. It ran great for about 50 miles, then it started missing and not running right. I cleaned the carbs, and put new plugs in it, and its still not running good. I have to give it gas to start it, and then it backfires, and smokes black. I suspect the timing now. So my qestion it, what are the timing marks? Or what may it be? Thank you very much.
Timing has never made an engine puff black smoke. You have a carb problem. Might be a bad coil but carbs is way more likely.
1979 KZ-750 Twin
Last edit: 02 Oct 2010 19:52 by bountyhunter.

Please Log in or Create an account to join the conversation.

  • bountyhunter
  • bountyhunter's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 7245
  • Thanks: 338

Re: Timing marks on 77 kz650?

02 Oct 2010 19:54
#403600
650ed wrote:
If it ran great fo 50 miles I don't see how the timing would be the issue. Sounds like carbs or possibly just bad gas. I would drain fuel and put in new fuel along with a fuel filter. If that doesn't do it, I would clean the carbs again very carefully. Otherwise, if you mess with the timing and it's a fuel problem you will end up with a fuel problem and a timing problem. Ed
+1 and make sure you have very good inline fuel filters or the crud in the tank will keep plugging the jets. Guess how I learned that....:laugh:
1979 KZ-750 Twin

Please Log in or Create an account to join the conversation.

  • bountyhunter
  • bountyhunter's Avatar
  • Offline
  • User
  • User
    Registered
  • Posts: 7245
  • Thanks: 338

Re: Timing marks on 77 kz650?

02 Oct 2010 19:55
#403601
Dylansword wrote:
I got my timing light on it, and if its advanced all the way, the still dont line up. And of course get even further away as i retard it. Could something faulty in the ignition system cause, backfiring, black smoke, carbonated plugs, lacking of power, and general running rough? If so, what could be causing it? Thanks
The timing advancer could be stuck.
1979 KZ-750 Twin

Please Log in or Create an account to join the conversation.

Moderators: Street Fighter LTD
Powered by Kunena Forum